PT00A-20-41PW Datasheet, PDF (1/7 Pages) Amphenol Corporation – Proprietary/MIL-C-26482, Series 1

Amphenol^® Miniature Cylindrical
Proprietary/MIL-C-26482, Series 1
PT
MIL-C-26482, Series 1
PT-SE
MIL-C-26482, Series 1
SP
DESIGN CHARACTERISTICS
• Medium size, widely used cylindrical
• Operating voltage to 1,000 VAC (RMS) at sea level
• Environment resistant
• Quick positive three point bayonet lock coupling
system
• Visual confirmation of complete coupling
• Five key/keyway polarization
• PT solder is UL Recognized under file #E115497,
Vol. 1, Section 5
CUSTOMER OPTIONS
• Seven mounting styles provide optimum design
flexibility
• Ten shell sizes 6 through 24
• Solder or crimp front or rear release contacts
• Size 20 through 12 contacts accept wire sizes 20
through 12 AWG
• Various finishes provide protection in a wide variety of
corrosive and mechanical environments
- Availability of zinc cobalt* non-cadmium plating
• Coaxial and thermocouple contact options
• Hermetic seal (glass fused) receptacles
• Double stub threaded coupling series available
• Alternate positioning
Amphenol^® Miniature Cylindrical connectors offer twice the
number of contacts in just half the size of a Standard connector.
These miniature connectors, are available in several series,
each with varying design characteristics and customer options
to meet cost considerations and provide maximum design flexi-
bility. Two of the Miniature Family series, MS/PT and MS/PT-SE,
are MS approved and qualified to MIL-C-26482, Series 1.
The Miniature family consists of three basic series: PT, SP and
PC. In all series, pin and socket contacts are machined from low
loss copper alloy and gold plated to eliminate contact corrosion
and provide an indefinite shelf life. All series incorporate closed
entry socket contacts. The PT, SP and PC series are provided
with factory installed solder contacts. Printed circuit board con-
tacts are available in the PT Series box mount and jam nut style
receptacles.
The PT, SP and PC series are also available with removable
crimp contacts incorporating either of two types of retention
systems. The suffix “SE” or “CE” refers to the type of retention
system employed. MS approved “SE” types utilize a spring
tower retention system, while the proprietary “CE” types utilize
a nylon wafer retention system to maintain contact position.
Hermetically sealed receptacles are available in the PT and PC
series.
Note:
Please refer to page 54 for a brief description of the Amphenol^®/Matrix^® MIL-C-
26482, Series 2 bayonet coupling connectors with crimp, rear insertable and
rear releasable contacts, and ask for catalog 12-071 for detailed information on
this series.
1
* For more information on zinc cobalt plating for connectors ask for Amphenol
Product Data Sheet #172.