HV05-15 Datasheet, PDF (1/1 Pages) American Microsemiconductor – High Voltage Rectifier

HV05-15
High Voltage Rectifier
NOTE:
TO ORDER WITH QUICK DISCONNECT
TERMINALS, REFER HV05-15-qd
DURING ORDERING PROCESS.
FEATURES
 Avalanche Breakdown Protection
 Low Forward Voltage Drop
 Typical IR less than 0.1 μA
 High Overload Surge Capacity
ABSOLUTE MAXIMUM RATINGS
VRRM REPEATING PEAK REVERSE VOLTAGE (KV): 15
TJMAX MAX. JUNCTION TEMP.(°C):……………….. 120
TSTG STORAGE TEMP.(°C):………………………….. -40 TO +120
IO AVG. FORWARD CURRENT (MA):……………. 550
IFSM FORWARD SURGE CURRENT (A): ………….. 44
ELECTRICAL CHARACTERISTICS
IR1 Normal temp. Reverse Current (ΜA):.. 5.0 MAX
IR2 High temp. Reverse Current (ΜA):…….. 50 MAX
VF FORWARD VOLTAGE (V):………………………….. 12 MAX
TEST CONDITIONS
HIGH TEMP. REVERSE VOLTAGE @ 1000 HRS.: ….. VRM=VRRM, F=50HZ, TAMB=100°C HALF SINE
VOLTAGE WITH F=50HZ APPLIED, TAMB=100°C
HIGH TEMP. STORAGE @ 1000 HRS.:……………….. TAMB=130±2°C
SOLDERING RESISTANCE HEAT TEST:…………………. SOLDER TROUGH TEMP.: 350±10°C, DIP TIME: 3.5S ± 0.5S
HIGH PRESSURE SMOKE TEST @ 10 HRS.:…………… 120°C, 2 X 105PA
INSULATION RESISTANCE TEST (1000MΩ):……….. BETWEEN THE CENTER OF THE BODY AND TERMINAL (SEE FIG. 1)
INSULATION STRENGTH TEST @ 10KV:…………….. 1 MIN. BETWEEN CENTER OF THE BODY AND TERMINAL. (FIG.1 )
LEAD BEND TEST:………………………………………….. FORCE 10 N TO THE LEAD, BENT IT TO POS. AND neg. 90°
LEAD PULL TEST:…………………………………………… FORCE 70 N OF AXIAL TO THE LEAD FOR 1 MIN.
Insulation resistance test condition: Measure between A
and B by using a DC 500V Insulation resistance tester
Insulation strength test condition: Apply half sine wave
voltage with 10kV wave height between A and B in
insulation liquid
Tel. [phone], Fax. [phone]
133 Kings Road,
Madison, New Jersey 07940
United States of America
© 2013 American Microsemiconductor, Inc.
Specifications are subject to change without notice.
www.americanmicrosemi.com
Document Page 1 of 1
Revised 06/2013
Aerospace Mgmt. Sys. Cert.
AS/EN/JISQ9100:2009 Rev. C
ISO9001:2008
Cert No. 45325