A25L032_15 Datasheet, PDF (39/48 Pages) AMIC Technology – 32Mbit Low Voltage, Dual-I/O Serial Flash Memory

Absolute Maximum Ratings*
Storage Temperature (TSTG) . . . . . . . . . . -65°C to + 150°C
Lead Temperature during Soldering (Note 1)
D.C. Voltage on Any Pin to Ground Potential . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.6V to V_CC+0.6V
Transient Voltage (<20ns) on Any Pin to Ground Potential . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -2.0V to V_CC+2.0V
Supply Voltage (V_CC) . . . . . . . . . . . . . . . . . . -0.6V to +4.0V
Electrostatic Discharge Voltage (Human Body model)
(VESD) (Note 2) . . . . . . . . . . . . . . . . . . . -2000V to 2000V
Notes:
1. Compliant with JEDEC Std J-STD-020B (for small body,
Sn-Pb or Pb assembly).
2. JEDEC Std JESD22-A114A (C1=100 pF, R1=1500 Ω ,
R2=500Ω)
A25L032 Series
*Comments
Stressing the device above the rating listed in the Absolute
Maximum Ratings" table may cause permanent damage to
the device. These are stress ratings only and operation of
the device at these or any other conditions above those
indicated in the Operating sections of this specification is not
implied. Exposure to Absolute Maximum Rating conditions
for extended periods may affect device reliability. Refer also
to the AMIC SURE Program and other relevant quality
documents.
DC AND AC PARAMETERS
This section summarizes the operating and measurement
conditions, and the DC and AC characteristics of the device.
The parameters in the DC and AC Characteristic tables that
follow are derived from tests performed under the
Measurement Conditions summarized in the relevant tables.
Designers should check that the operating conditions in their
circuit match the measurement conditions when relying on
the quoted parameters.
Table 9. Operating Conditions
Symbol
Parameter
V_CC
Supply Voltage
T_A
Ambient Operating Temperature
Min.
Max.
Unit
2.7
3.6
V
–40
85
°C
Table 10. Data Retention and Endurance
Parameter
Condition
Erase/Program Cycles At 85°C
Data Retention
At 85°C
Min.
100,000
20
Max.
Unit
Cycles
Years
Table 11. Capacitance
Symbol
Parameter
Test Condition
Min.
Max.
Unit
C_OUT
Output Capacitance (DO)
V_OUT = 0V
C_IN
Input Capacitance (other pins)
V_IN = 0V
Note: Sampled only, not 100% tested, at TA=25°C and a frequency of 33 MHz.
8
pF
6
pF
(December, 2014, Version 1.5)
38
AMIC Technology Corp.