AMIS-734256 Datasheet, PDF (7/9 Pages) AMI SEMICONDUCTOR – 25μm-pitch Wide Aperture Spectroscopic Photodiode Arrays

AMIS-734256, AMIS-734512, AMIS-734024
25µm-pitch Wide Aperture Spectroscopic Photodiode Arrays
Data Sheet
9.0 Recommended Operating Conditions
Table 3 lists the recommended operating conditions.
Table 3: Recommended Operating Conditions at 25^°C
Parameters
Symbol
Min.
Typ.
Max.
Units
Power supply
Input clock pulses high level ⁽¹⁾
Input clock pulse low level ⁽¹⁾
VDD
Vih
Vil
4.5
VDD – 0.8
0.0
5.0
VDD
0.0
5.5
VDD
0.8
Volts
Volts
Volts
Video charge output external bias
Vbias
VDD – 0.5
VDD – 0.5
VDD
Volts
Clock frequency
Fclk
0.1
1.0
MHz
Integration time ⁽²⁾
Tint
0.26 (734256)
0.52 (734512)
11000 (w/ cap)
ms
1.03 (734024)
Notes:
(1) Applies to all control-clock inputs.
(2) Integration time is specified at room temperature such that the maximum dark current charge build up in each pixel is less than 10 percent of the minimum
saturation charge. Accordingly, it may be as long as 11 seconds at room temperature with the added capacitors. Longer integration times may be achieved by
cooling the device. An appropriate clock frequency must be chosen so that the shift register completes its operation within the desired integration time.
10.0 Electro-Optical Characteristics
Table 4 lists the electro-optical characteristics.
Table 4: Electro-Optical Characteristics at 25^°C
Parameters
Symbol
Min.
Typ.
Max.
Units
Center-to-center spacing
25
µm
Aperture width
Pixel area
A
Fill factor ⁽¹⁾
FF
Quantum efficiency ⁽¹⁾⁽²⁾
QE
Responsivity ⁽¹⁾⁽²⁾
R
Non-uniformity of response ⁽³⁾
2500
6.25 x 10^-4
72
70
1.5 x 10^-4
2
µm
cm²
%
%
C/J/cm²
+/-%
Saturation exposure ⁽²⁾
Esat
370 (w/cap)
130 (w/o cap)
430 (w/ cap)
170 (w/o cap)
nJ/cm²
Saturation charge ⁽⁴⁾
Qsat
55 (w/cap)
20 (w/o cap)
65 (w/cap)
25 (w/o cap)
pC
Average dark current ⁽⁵⁾
0.2
pA
Spectral response peak
λ
Spectral response range ⁽⁶⁾
600
nm
180 - 1000
nm
Notes:
(1)
(2)
(3)
(4)
(5)
(6)
Fill factor, quantum efficiency and responsivity are related by the equation R = (qel/hc).QE.FF.A, where qe is the charge of an electron and hc/l is the energy of a
photon at a given wavelength. Responsivity is therefore given per pixel.
At wavelength of 575nm (Yellow-Green) and with no window.
Measured at 50 percent Vsat with an incandescent tungsten lamp filtered with an Schott KG-1 heat-absorbing filter.
Saturation charge specified for a video output bias of 4.5V.
Max dark leakage £ 1.5 x average dark leakage measured with an integration period of 500ms at 25^°C.
From 250-1000nm, responsivity ³ 20 percent of its peak value.
AMI Semiconductor – Aug. 06, M-20603-001
7
www.amis.com