AMIS-710651 Datasheet, PDF (7/9 Pages) AMI SEMICONDUCTOR – Color CIS Module

AMIS-710651-A4: Color CIS Module
Data Sheet
11.0 I/O Connector Pin Configuration
The connector is for a 12-pin flex-strip-line cable, PDK97-1201. The connector location is shown in Figure 6, an ISO drawing of the
AMIS-710651-A4 module. It also shows the location of Pin 1.
Use caution when connecting the power to the LED!
Note that all the negative sides of the LED sources are connected to the cathodes. These I/O sources are current inputs.
Constant current sources are used to control the balance of the color in the RGB outputs. Their typical voltage drops are between 2.3 to
2.7V. Under no circumstances should the applied current be greater than 30mA, otherwise the LED source will be damaged.
Table 8: Connector Pin Outs
Pin Number
Pin Names
1
Analog signal output
2
Ground
3
Power supply
4
DPI-control
5
Reference voltage
6
Start pulse
7
Ground
8
Clock
9
Common
10
LED green
11
LED red
12
LED blue
Symbol
VOUT
GND
VDD
SR
VREF
SP
GND
CP (CLK on the schematic)
VLED (common anode on the schematic)
GLED
RLED
BLED
I/0 Names and Functions
O Analog signal output
I Ground; 0V
I Positive 3.3V
I Selects resolution control
I
For externally or internally controlling the dark
bias level
I Shift register start pulse
I Ground; 0V
I Clock input for the module
I Common anodes for all LED, plus 5.0V terminal
I Cathode green LED input
I Cathode red LED input
I Cathode blue LED input
AMI Semiconductor – Aug. 06, M-20609-001
7
www.amis.com