|
AMIS-710214 Datasheet, PDF (1/8 Pages) AMI SEMICONDUCTOR – 200dpi Two Level Digital Output Module | |||
|
AMIS-710214: 200dpi Two Level Digital Output Module
Data Sheet
1.0 General Description
The AMIS-710214 (PI214MC-DR) is a contact image sensor (CIS) module with an additional on-board circuit that digitizes the analog
pixels from the CIS image sensor to a âbackground-trackingâ, two-level digital output signal. It is based on AMI Semiconductorâs CIS
module that employs MOS image sensor technology to gain its high-speed performance and high sensitivity. The AMIS-710214 is
suitable for scanning documents with width of 216mm and with resolution of 8 dots per millimeter (dpm). It has broad applications, but
is specially designed for the following areas:
⢠Where data compression is required, such as in data transmissions.
⢠Where component pin-out count must be kept to a minimum.
The background-tracking-digitizing circuits in the AMIS-710214 have been referred to as the âdynamic thresholdâ two-level A/D
converter. For the purpose of describing the moduleâs characteristics this âdynamic thresholdâ processing circuit shall herein be referred
to as the âtracking digitizerâ.
2.0 Key Features
⢠Light source, lens and sensor are integrated into a single module
⢠8dpm resolution, 216mm scanning length
⢠Up to 440µsec/line scanning speed, with 4.0MHz pixel rate (See Table 3, Note 2)
⢠Wide dynamic range
⢠Two-level tracking digital output (âDynamic Threshold Digitizerâ)
⢠Red (660nm) light source (other colors are available)
⢠Compact size â
19.5mm x 21.5mm x 232mm
⢠Low power
⢠Light weight
3.0 Module Description
Figure 1: Block Diagram of AMIS-710214
AMI Semiconductor â May 06, M-20539-001
1
www.amis.com
|
▷ |