AME5253 Datasheet, PDF (8/18 Pages) Analog Microelectronics – 1A, 1.5MHz Synchronous Step-Down Converter

AME
AME5253
1A, 1.5MHz Synchronous
Step-Down Converter
The selection of C_OUT is determined by the effective
series resistance(ESR) that is required to minimize volt-
age ripple and load step transients. The output ripple,
V_OUT, is determined by:
∆V_OUT ≅ ∆I _L
ESR + ¹
8 fC_OUT
Using Ceramic Input and Output Capacitors
Higher values, lower cost ceramic capacitors are now
becoming available in smaller case sizes. Their high ripple
current, high voltage rating and low ESR make them ideal
for switching regulator applications. However, care must
be taken when these capacitors are used at the input and
output. When a ceramic capacitor is used at the input
and the power is supplied by a wall adapter through long
wires, a load step at the output can induce ringing at the
input, V_IN. At best, this ringing can couple to the output
and be mistaken as loop instability. At worst, a sudden
inrush of current through the long wires can potentially
cause a voltage spike at V_IN large enough to damage the
part.
Output Voltage Programming
The output voltage is set by an external resistive divider
according to the following equation:
V_OUT
= V_REF ×
1 + ^R1
R₂
Where VREF equals to 0.6V typical. The resistive di-
vider allows the FB pin to sense a fraction of the output
voltage as shown in Figure 3.
0.6V ≤ VOUT ≤ 5.5V
Thermal Considerations
In most applications the AME5253 does not dissipate
much heat due to its high efficiency. But, in applications
where the AME5253 is running at high ambient tempera-
ture with low supply voltage and high duty cycles, such
as in dropout, the heat dissipated may exceed the maxi-
mum junction temperature of the part. If the junction tem-
perature reaches approximately 160^OC, both power
switches will be turned off and the SW node will become
high impedance. To avoid the AME5253 from exceeding
the maximum junction temperature, the user will need to
do some thermal analysis. The goal of the thermal analy-
sis is to determine whether the power dissipated exceeds
the maximum junction temperature of the part. The tem-
perature rise is given by:
T_R = (PD)(θ_JA )
Where PD is the power dissipated by the regulator and
θ_JA is the thermal resistance from the junction of the die
to the ambient temperature.
R1
FB
AME5253
R2
GND
Figure 3. Setting the AME 5253 Output Voltage
8
Rev. A.04