|
AM29F200A Datasheet, PDF (1/39 Pages) Advanced Micro Devices – 2 Megabit (256 K x 8-Bit/128 K x 16-Bit) CMOS 5.0 Volt-only, Boot Sector Flash Memory | |||
|
PRELIMINARY
Am29F200A
2 Megabit (256 K x 8-Bit/128 K x 16-Bit)
CMOS 5.0 Volt-only, Boot Sector Flash Memory
DISTINCTIVE CHARACTERISTICS
s 5.0 V ± 10% for read and write operations
â Minimizes system level power requirements
s High performance
â Access times as fast as 55 ns
s Low power consumption
â 20 mA typical active read current (byte mode)
â 28 mA typical active read current for
(word mode)
â 30 mA typical program/erase current
â 1 µA typical standby current
s Sector erase architecture
â One 16 Kbyte, two 8 Kbyte, one 32 Kbyte, and
three 64 Kbyte sectors (byte mode)
â One 8 Kword, two 4 Kword, one 16 Kword, and
three 32 Kword sectors (word mode)
â Supports full chip erase
â Sector Protection features:
A hardware method of locking a sector to
prevent any program or erase operations within
that sector
Sectors can be locked via programming
equipment
Temporary Sector Unprotect feature allows code
changes in previously locked sectors
s Top or bottom boot block configurations
available
s Embedded Algorithms
â Embedded Erase algorithm automatically
preprograms and erases the entire chip or any
combination of designated sectors
â Embedded Program algorithm automatically
writes and verifies data at specified addresses
s Minimum 100,000 write/erase cycles guaranteed
s Package options
â 44-pin SO
â 48-pin TSOP
s Compatible with JEDEC standards
â Pinout and software compatible with
single-power-supply flash
â Superior inadvertent write protection
s Data# Polling and Toggle Bit
â Detects program or erase cycle completion
s Ready/Busy# output (RY/BY#)
â Hardware method for detection of program or
erase cycle completion
s Erase Suspend/Erase Resume
â Supports reading data from a sector not being
erased
s Hardware RESET# pin
â Resets internal state machine to the reading
array data
Publication# 20637 Rev: B Amendment/+3
Issue Date: March 1998
|
▷ |