EPF10K100ABC356-3 Datasheet, PDF (47/128 Pages) Altera Corporation – Embedded Programmable Logic Device Family

FLEX 10K Embedded Programmable Logic Device Family Data Sheet
Notes to tables:
(1) See the Operating Requirements for Altera Devices Data Sheet.
(2) Minimum DC input voltage is –0.5 V. During transitions, the inputs may undershoot to –2.0 V for input currents
less than 100 mA and periods shorter than 20 ns.
(3) Numbers in parentheses are for industrial-temperature-range devices.
(4) Maximum V_CC rise time is 100 ms. V_CC must rise monotonically.
(5) Typical values are for T _A = 25° C and V_CC = 5.0 V.
(6) These values are specified under the Recommended Operation Condition shown in Table 18 on page 45.
(7) The I_OH parameter refers to high-level TTL or CMOS output current.
(8) The I_OL parameter refers to low-level TTL or CMOS output current. This parameter applies to open-drain pins as
well as output pins.
(9) This value is specified for normal device operation. The value may vary during power-up.
(10) Capacitance is sample-tested only.
Figure 20 shows the typical output drive characteristics of FLEX 10K
devices with 5.0-V and 3.3-V V_CCIO. The output driver is compliant with
the 5.0-V PCI Local Bus Specification, Revision 2.2 (for 5.0-V V_CCIO).
Figure 20. Output Drive Characteristics of FLEX 10K Devices
5.0-V
3.3-V
150
I_OL
150
120
Typical I_O ⁹⁰
Output
Current (mA)
60
30
V_CCINT = 5.0 V
V_CCIO = 5.0 V
Room Temperature
I_OH
120
Typical I_O ⁹⁰
Output
Current (mA)
60
45
30
I_OL
V_CCINT = 5.0 V
V_CCIO = 3.3 V
Room Temperature
I_OH
1
2
3
4
5
V_O Output Voltage (V)
1
2
3 ^3.3 4
5
V_O Output Voltage (V)
Altera Corporation
47