5M240ZM68I5N Datasheet, PDF (4/30 Pages) Altera Corporation – DC and Switching Characteristics for MAX V Devices

3–4
Chapter 3: DC and Switching Characteristics for MAX V Devices
Operating Conditions
Table 3–4. DC Electrical Characteristics for MAX V Devices (Note 1) (Part 2 of 2)
Symbol
Parameter
Conditions
Minimum Typical Maximum Unit
I/O pin pull-up resistor
I_PULLUP
current when I/O is
—
unprogrammed
—
—
300
µA
C_IO
Input capacitance for
user I/O pin
—
—
—
8
pF
Input capacitance for
C_GCLK
dual-purpose GCLK/user
—
I/O pin
—
—
8
pF
Notes to Table 3–4:
(1) Typical values are for T_A = 25°C, V_CCINT = 1.8 V and V_CCIO = 1.2, 1.5, 1.8, 2.5, or 3.3 V.
(2) This value is specified for normal device operation. The value may vary during power-up. This applies to all V_CCIO settings (3.3, 2.5, 1.8, 1.5,
and 1.2 V).
(3) V_I = ground, no load, and no toggling inputs.
(4) Commercial temperature ranges from 0°C to 85°C with the maximum current at 85°C.
(5) Not applicable to the T144 package of the 5M240Z device.
(6) Only applicable to the T144 package of the 5M240Z device.
(7) Industrial temperature ranges from –40°C to 100°C with the maximum current at 100°C.
(8) This value applies to commercial and industrial range devices. For extended temperature range devices, the V_SCHMITT typical value is 300 mV
for V_CCIO = 3.3 V and 120 mV for V_CCIO = 2.5 V.
(9) The TCK input is susceptible to high pulse glitches when the input signal fall time is greater than 200 ns for all I/O standards.
(10) This is a peak current value with a maximum duration of t_CONFIG time.
(11) Pin pull-up resistance values will lower if an external source drives the pin higher than V_CCIO.
MAX V Device Handbook
May 2011 Altera Corporation