EPF6016AQC208-2 Datasheet, PDF (32/52 Pages) Altera Corporation – Programmable Logic Device Family

FLEX 6000 Programmable Logic Device Family Data Sheet
Table 13. FLEX 6000 5.0-V Device DC Operating Conditions Notes (5), (6)
Symbol
Parameter
Conditions
V _IH
V _IL
V _OH
V _OL
I_I
I _OZ
I _CC0
High-level input voltage
Low-level input voltage
5.0-V high-level TTL output
voltage
I_OH = –8 mA DC, V_CCIO = 4.75 V (7)
3.3-V high-level TTL output
voltage
I_OH = –8 mA DC, V_CCIO = 3.00 V (7)
3.3-V high-level CMOS output
voltage
I_OH = –0.1 mA DC, V_CCIO = 3.00 V (7)
5.0-V low-level TTL output
voltage
I_OL = 8 mA DC, V _CCIO = 4.75 V (8)
3.3-V low-level TTL output
voltage
I_OL = 8 mA DC, V _CCIO = 3.00 V (8)
3.3-V low-level CMOS output
voltage
I_OL = 0.1 mA DC, V_CCIO = 3.00 V (8)
Input pin leakage current
V_I = V_CC or ground (8)
Tri-stated I/O pin leakage current V_O = V_CC or ground (8)
V_CC supply current (standby)
V_I = ground, no load
Min Typ Max Unit
2.0
–0.5
2.4
V_CCINT + 0.5 V
0.8
V
V
2.4
V
V_CCIO – 0.2
V
0.45
V
0.45
V
0.2
V
–10
10
µA
–40
40
µA
0.5
5
mA
Table 14. FLEX 6000 5.0-V Device Capacitance Note (9)
Symbol
Parameter
Conditions
C _IN
C_INCLK
C _OUT
Input capacitance for I/O pin
V_IN = 0 V, f = 1.0 MHz
Input capacitance for dedicated input V_IN = 0 V, f = 1.0 MHz
Output capacitance
V_OUT = 0 V, f = 1.0 MHz
Min
Max Unit
8
pF
12
pF
8
pF
Notes to tables:
(1) See the Operating Requirements for Altera Devices Data Sheet.
(2) Minimum DC input is –0.5 V. During transitions, the inputs may undershoot to –2.0 V or overshoot to 7.0 V for
input currents less than 100 mA and periods shorter than 20 ns.
(3) Numbers in parentheses are for industrial-temperature-range devices.
(4) Maximum V_CC rise time to 100 ms. V_CC must rise monotonically.
(5) Typical values are for T_A = 25° C and V_CC = 5.0 V.
(6) These values are specified under the FLEX 6000 Recommended Operating Conditions shown in Table 12 on
page 31.
(7) The I_OH parameter refers to high-level TTL or CMOS output current.
(8) The I_OL parameter refers to low-level TTL, PCI, or CMOS output current. This parameter applies to open-drain pins
as well as output pins.
(9) Capacitance is sample-tested only.
32
Altera Corporation