EPM3064ATC100-4 Datasheet, PDF (24/46 Pages) Altera Corporation – Programmable Logic Device Family

MAX 3000A Programmable Logic Device Family Data Sheet
Table 15. MAX 3000A Device Capacitance Note (9)
Symbol
Parameter
Conditions
Min
Max Unit
C_IN
Input pin capacitance
C_I/O
I/O pin capacitance
V_IN = 0 V, f = 1.0 MHz
V_OUT = 0 V, f = 1.0 MHz
8
pF
8
pF
Notes to tables:
(1) See the Operating Requirements for Altera Devices Data Sheet.
(2) Minimum DC input voltage is –0.5 V. During transitions, the inputs may undershoot to –2.0 V or overshoot to
5.75 V for input currents less than 100 mA and periods shorter than 20 ns.
(3) All pins, including dedicated inputs, I/O pins, and JTAG pins, may be driven before V_CCINT and V_CCIO are
powered.
(4) These values are specified under the recommended operating conditions, as shown in Table 13 on page 23.
(5) The parameter is measured with 50% of the outputs each sourcing the specified current. The I_OH parameter refers
to high–level TTL or CMOS output current.
(6) The parameter is measured with 50% of the outputs each sinking the specified current. The I_OL parameter refers to
low–level TTL, PCI, or CMOS output current.
(7) This value is specified during normal device operation. During power-up, the maximum leakage current is
±300 μA.
(8) This pull–up exists while devices are programmed in–system and in unprogrammed devices during power–up.
(9) Capacitance is measured at 25° C and is sample–tested only. The OE1 pin (high–voltage pin during programming)
has a maximum capacitance of 20 pF.
(10) The POR time for all MAX 3000A devices does not exceed 100 μs. The sufficient V_CCINT voltage level for POR is
3.0 V. The device is fully initialized within the POR time after V_CCINT reaches the sufficient POR voltage level.
(11) These devices support in-system programming for –40° to 100° C. For in-system programming support between –40°
and 0° C, contact Altera Applications.
Figure 9 shows the typical output drive characteristics of MAX 3000A
devices.
24
Altera Corporation