EPC1PC8 Datasheet, PDF (20/26 Pages) Altera Corporation – Configuration Devices for SRAM-Based LUT Devices

Page 20
Operating Conditions
Table 15. EPC1064, EPC1064V, and EPC1213 Devices I_CC Supply Current Values
Symbol
Parameter
Conditions
Min
Typ
Max
Unit
I_CC0
V_CC supply current (standby)
—
—
100
200
A
I_CC1
V_CC supply current (during configuration)
—
—
10
50
mA
Table 16. EPC2 Device Values
Symbol
I_CC0
I_CC1
R_CONF
Parameter
V_CC supply current (standby)
V_CC supply current (during
configuration)
Configuration pins
Conditions
V_CC = 5.0 V or 3.3 V
V_CC = 5.0 V or 3.3 V
Internal pull up (OE, nCS,
nINIT_CONF)
Min
Typ
Max
Unit
—
50
100
µA
—
18
50
mA
—
1
—
k
Table 17. EPC1 Device I_CC Supply Current Values
Symbol
Parameter
Conditions
Min
Typ
Max
Unit
I_CC0
V_CC supply current (standby)
—
—
I_CC1
V_CC supply current (during configuration)
V_CC = 5.0 V
V_CC = 3.3 V
—
—
50
100
µA
30
50
mA
10
16.5
mA
Table 18. EPC1441 Device I_CC Supply Current Values
Symbol
Parameter
Conditions
Min
Typ
Max
Unit
I_CC0
V_CC supply current (standby)
—
—
30
60
µA
I_CC1
V_CC supply current (during configuration) V_CC = 5.0 V
—
15
30
mA
I_CC1
V_CC supply current (during configuration) V_CC = 3.3 V
—
5
10
mA
Table 19. Capacitance ⁽⁷⁾
Symbol
Parameter
Conditions
Min
Max
Unit
C_IN
Input pin capacitance
V_IN = 0 V, f = 1.0 MHz
—
10
pF
C_{O UT}
Output pin capacitance
V_OUT = 0 V, f = 1.0 MHz
—
10
pF
Notes to Table 12 through Table 19:
(1) For more information, refer to the Operating Requirements for Altera Devices Datasheet.
(2) The minimum DC input is -0.3 V. During transitions, the inputs may undershoot to -2.0 V or overshoot to 7.0 V for input currents less than
100 mA and periods shorter than 20 ns under no-load conditions.
(3) Numbers in parentheses are for industrial temperature range devices.
(4) Maximum V_CC rise time is 100 ms.
(5) Certain EPC2 device pins are driven to 5.75 V when operated with a 3.3-V V_CC. For more information, refer to Table 4 on page 11.
(6) The I_OH parameter refers to high-level TTL or CMOS output current and the I_OL parameter refers to low-level TTL or CMOS output current.
(7) Capacitance is sample tested only.
Configuration Devices for SRAM-Based LUT Devices
January 2012 Altera Corporation