PSP480_1 Datasheet, PDF (1/2 Pages) Altech corporation – 480W Single Phase Industrial DIN Rail Power Supply

480W Single Phase Industrial DIN Rail Power Supply
PSP-480 Series
F ea tures :
B uilt-in pa s s ive P F C f unction c omplia nce to E N61000-3-2(F or D R P -480)
High e fficiency 8 9% a nd low dis s ipa tion
P rotections :S hort circuit/O ver loa d/O ver v olta ge/O ver tempera ture
C ooling by f ree a ir c onvection
B uilt-in c ons ta nt current limiting c ircuit
C a n be i ns ta lled on D IN r a il T S -35/7.5 o r 1 5
U L 5 08(indus tria l c ontrol e quipment)a pproved
E N61000-6-2(E N50082-2) i ndus tria l immunity l evel
100% f ull load burn-in tes t
3 y ea rs w a rra nty
R
S PE CIFICATION
MODE L
PSP-48024
PSP-48048
OUTPUT
DC VOLTAGE
24V
RATED CURRENT
20A
CURRENT RANGE
0 ~ 20A
RATED POWER
480W
RIPPLE & NOISE (max.) Note.2
120mVp-p
VOLTAGE ADJ . R ANGE
24 ~ 28V
VOLTAGE TOLERANCE Note.3
1.0%
LINE R EGULATION
0.5%
LOAD REGULATION
1.0%
SETUP, R ISE, HOLD TIME 1200ms, 40ms, 16ms/230VAC at full load
48V
10A
0 ~ 10A
480W
120mVp-p
48 ~ 53V
1.0%
0.5%
1.0%
INPUT
VOLTAGE R ANGE
FREQUENCY RANGE
POWER FACTOR
EFFICIENCY (Typ.)
AC CURRENT
INRUSH CURRENT (max.)
180 ~ 264VAC 2 50 ~ 370VDC
47 ~ 63Hz
0.7 (for DRP-480)
89%
4A/230V AC
COLD START 40A/230V AC
4A/230VAC
LEAKAGE C URRENT
<3.5mA / 240VAC
OVER L OAD
105 ~ 150% rated output power
Protection type : Constant current limiting, recovers automatically after fault condition is removed
PROTECTION OVER VOLTAGE
30 ~ 36V
54 ~60V
30 ~ 36V
Protection type : Shut down o/p voltage, re-power on to recover
54 ~60V
OVER TEMPERATURE
100 5 (TSW : Detect on heatsink of power switch)
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
WORKING TEMP.
-20 ~ +70 (Refer to output load derating curve)
WORKING HUMIDITY
20 ~ 90% RH non-condensing
ENVIRONMENT STORAGE TEMP., HUMIDITY -20 ~ +85 , 10 ~ 95% RH
TEMP. COEFFICIENT
0.03%/ (0 ~ 50
VIB R ATION
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
SAFETY STANDARDS
UL508, EN60950 Approved, UL60950-1
WITHSTAND VOLTAGE
I/P-O/P:3KVAC I /P-FG:1.5KVAC O/P-FG:0.5KVAC
SAFETY & ^{ISOLATION RESISTANCE}
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC
E MC
EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B
(Note 4) _{HARMONIC CURRENT}
Compliance to EN61000-3-2,-3(For DRP-480)
OTHE R S
NOTE
EMS IMMUNITY
Compliance to EN61000-4-2,3,4,5,61,8, ,E1NV50204, EN61000-6-2 (EN50082-2) Heavy industry level, crAiteria
MTB F
180.9Khrs min. MIL-HDBK-217F (25 )
DIME NS ION
227*125.2*100mm (W*H*D)
PACK ING
2.4Kg; 6pcs/15Kg/1.75CUFT
1. A ll parameters N OT s pecially mentioned a re measured a t 230VAC i nput, r ated load a nd 25 of ambient temperature.
2. R ipple & n oise a re measured a t 20MHz o f bandwidth by using a 1 2" twisted pair-wire terminated with a 0 .1uf & 4 7uf parallel capacitor.
3. T olerance : i ncludes s et up tolerance, line regulation a nd load regulation.
4. T he power s upply is c onsidered a c omponent which will be installed into a f inal equipment. T he final equipment must be re-confirmed that it still meets
E MC d irectives.
35 Royal Road, Flemington, NJ 08822-6000 • (tel.) 908-806-9400 • (fax) 908-806-9490 • www.altechcorp.com