English
Language : 

ASM1810 Datasheet, PDF (1/9 Pages) Alliance Semiconductor Corporation – Low Power, 5V uP Reset Active LOW, Push-Pull Output
February 2005
ASM1810
rev 1.4
Low Power, 5V µP Reset
- Active LOW, Push-Pull Output
General Description
The ASM1810 is a voltage supervisor with low-power, 5V µP
active LOW Reset, Push-Pull output. Maximum supply current
over temperature is a low 20µA.
The ASM1810 generates an active LOW reset signal whenever
the monitored supply is out of tolerance. A precision reference
and comparator circuit monitor power supply (VCC) level.
Tolerance level options are 5%, 10% and 15%. When an out-of-
tolerance condition is detected, an internal power-fail signal is
generated which forces an active LOW reset signal. After VCC
returns to an in-tolerance condition, the reset signal remains
active for 150ms to allow the power supply and system
microprocessor to stabilize.
Key Features
• Low Supply Current
•20 µA maximum (5.5 V)
• Automatically restarts a microprocessor after power failure
• 150ms reset delay after VCC returns to an in-tolerance con-
dition
• Active LOW power-up reset
• Precision temperature-compensated voltage reference and
comparator
• Eliminates external components
• Low cost TO-92 and compact surface mount SOT-23 pack-
age
• Push-Pull output for minimum current drain
• Operating temperature -40°C to +85°C
The ASM1810 is designed with a push-pull output stage and
operates over the extended industrial temperature range.
Devices are available in low cost TO-92 and compact surface
mount SOT-23 packages.
Other low power products in this family include the ASM1811/
12/15/16/17, ASM1233D and ASM1233M.
Typical Operating Circuit
VCC
ASM1810
RESET
Microprocessor
RESET
Applications
• Set-top boxes
• Cellular phones
• PDAs
• Energy management systems
• Embedded control systems
• Printers
• Single board computers
Block Diagram
VCC 2
Supply
Tolerance
Bias
+
-
Reference
ASM1810
Delay
150ms
Typical
1
RESET
GND
3
GND
Alliance Semiconductor
2575 Augustine Drive . Santa Clara, CA 95054 . Tel: 408.855.4900 . Fax: 408.855.4999 . www.alsc.com
Notice: The information in this document is subject to change without notice