AMG-PU005 Datasheet, PDF (13/14 Pages) alpha microelectronics gmbh – Analog System Base Chip, I/O PowerStage, OP-Amps

AMG-PU005
Analog System Base Chip, I/O PowerStage, OP-Amps
e
-
0.50
-
L
0.35
0.4
0.45
Θ
-12
-
0
ccc
-
0.08
-
M
-
-
0.05
10. IC-Marking
Top Marking by Laser
PU005
yyww
*******
Date Code
Lot Number
11. Ordering Information
AMG-PU005-IQN24R
(QFN24, Tape & Reel)
12. Notes and Cautions
12.1. ESD Protection
The Requirements for Handling Electrostatic Discharge Sensitive Devices are described in the
JEDEC standard JESD625-A. Please note the following recommendations:
 When handling the device, operators must be grounded by wearing a for the purpose
designed grounded wrist strap with at least 1MΩ resistance and direct skin contact.
 Operators must at all times wear ESD protective shoes or the area should be
surrounded by for ESD protection intended floor mats.
 Opening of the protective ESD package that the device is delivered in must only occur at
a properly equipped ESD workbench. The tape with which the package is held together
must be cut with a sharp cutting tool, never pulled or ripped off.
 Any unnecessary contact with the device or any unprotected conductive points should be
avoided.
 Work only with qualified and grounded tools, measuring equipment, casing and
workbenches.
 Outside properly protected ESD-areas the device or any electronic assembly that it may
be part of should always be transported in EGB/ESD shielded packaging.
AMG-PU005 Revision: B
9. Nov. 2012
© All rights reserved Page 13 of 14