3059 Datasheet, PDF (8/8 Pages) Allegro MicroSystems – HALL-EFFECT GEAR-TOOTH SENSORS -AC COUPLED

3059 AND 3060
HALL-EFFECT
GEAR-TOOTH SENSORS
—AC COUPLED
Dimensions in Inches
(controlling dimensions)
0.252
0.247
0.063
0.059
Dimensions in Millimeters
(for reference only)
6.40
6.27
1.60
1.50
0.181
0.176
0.083 1
2
3
4
5
MAX
0.600
0.560
SEE NOTE
45°
0.018
0.015
4.60
4.47
2.11 1
2
3
4
5
MAX
15.24
14.23
SEE NOTE
0.016
0.050
BSC
Dwg. MH-010G in
0.41
1.27
BSC
Surface-Mount Lead Form (Suffix -TL)
0.095
±0.005
2.41
±0.13
0.002
MAX
0.051
MAX
45°
0.46
0.38
Dwg. MH-010G mm
0.004 ^{0°–8°}
MAX
0.020
MIN
FLAT
Dwg. MH-015 in
0.10 ^{0°–8°}
MAX
0.51
MIN
FLAT
Dwg. MH-015 mm
NOTES: 1. Tolerances on package height and width represent allowable
mold offsets. Dimensions given are measured at the widest
point (parting line).
Allegro MicroSystems, Inc. reserves the right to make, from time to time, such
departures from the detail specifications as may be required to permit improve-
ments in the design of its products.
The information included herein is believed to be accurate and reliable.
However, Allegro MicroSystems, Inc. assumes no responsibility for its use; nor for
any infringements of patents or other rights of third parties which may result from
its use.
2. Exact body and lead configuration at vendor’s option within
limits shown.
3. Height does not include mold gate flash.
4. Recommended minimum PWB hole diameter to clear transition
area is 0.035” (0.89 mm).
5. Where no tolerance is specified, dimension is nominal.
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 [phone]