ATS660LSB Datasheet, PDF(1/16 Page) Allegro MicroSystems – TRUE ZERO-SPEED, HALL-EFFECT ADAPTIVE GEAR-TOOTH SENSOR

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

ATS660LSB Datasheet, PDF (1/16 Pages) Allegro MicroSystems – TRUE ZERO-SPEED, HALL-EFFECT ADAPTIVE GEAR-TOOTH SENSOR

ATS660LSB

Some restrictions may apply to cer-

tain types of sales. Contact factory

for details.

TRUE ZERO-SPEED, HALL-EFFECT

ADAPTIVE GEAR-TOOTH SENSOR

Pin 1 = Supply

Pin 2 = Output

Pin 3 = Internal Connection

Pin 4 = Ground

Dwg. AH-006-4

PRELIMINARY INFORMATION

(subject to change without notice)

October 20, 2000

ABSOLUTE MAXIMUM RATINGS

at TA = 25Â°C

Supply Voltage, VCC ........................ 26.5 V*

Reverse Supply Voltage, VRCC ............ -24 V

Output OFF Voltage, VOUT ................. 26.5 V

Reverse Output Voltage, VROUT .......... -24 V

Continuous Output Current, IOUT ....... 20 mA

Reverse Output Current, IROUT .......... 50 mA

Package Power Dissipation,

PD .......................................... See Graph

Operating Temperature Range,

TA ............................. -40Â°C to +150Â°C*

Junction Temperature,

(continuous), TJ .......................... +165Â°C

(100 hr), TJM ............................... +180Â°C

Storage Temperature, TS ................... +170Â°C

* Operation at increased supply voltages with

external circuitry is described in Applications

Information. Devices for operation at in-

creased temperatures are available on special

order.

The ATS660LSB is an ideal gear-tooth sensor solution for uniform

teeth targets as found in todayâs demanding transmission applications.

This digital differential Hall-effect sensor is the choice when repeatabil-

ity and timing accuracy count. The ATS660LSB incorporates patented

self-calibration circuitry (U.S. Pat. 5,917,320) that nulls out the effects

of installation air gap, ambient temperature, and magnet offsets to

provide superior timing accuracy with symmetrical targets over large

operating air gaps â typical of targets used in speed-sensing applica-

tions (pitches varying from below 0.5 to over 1.2 teeth per diametric

millimeter). The self-calibration at power up keeps the performance

optimized over the life of the sensor. The ATS660LSB has an open-

collector output for direct digital interfacing with no further signal

processing required. This device is available in a small 9-mm diameter

by 7-mm long package for optimal manufacturing.

The integrated circuit incorporates a dual-element Hall-effect

sensor and signal processing that switches in response to differential

magnetic signals created by the ferrous gear teeth. The circuitry

contains a sophisticated digital circuit to eliminate magnet and system

offsets and to achieve true zero-speed operation . D-to-A converters are

used to adjust the device gain at power on and to allow air-gap indepen-

dent switching, which greatly reduces vibration sensitivity of the

device.

FEATURES AND BENEFITS

I Fully optimized differential digital gear-tooth sensor

I Single-chip sensing IC for high reliability

I High vibration immunity

I Precise duty cycle

I Small mechanical size (9 mm diameter x 7 mm length)

I Automatic gain control circuitry (self calibration)

I True zero-speed operation

I Under-voltage lockout

I Wide operating temperature range

I Optimized Hall IC magnetic circuit

I Digital signal processing

I Large operating air gap range

I Wide operating voltage range

I Excellent repeatability performance

I Defined power-on state

Always order by complete part number: ATS660LSB .

▷