|
AKD4370-B Datasheet, PDF (9/30 Pages) Asahi Kasei Microsystems – 24bit DAC with Headphone Amplifier | |||
|
◁ |
ASAHI KASEI
[AKD4370-A]
Control Software Manual
Set-up of evaluation board and control software
1. Set up the AKD4370 according to previous term.
2. Connect IBM-AT compatible PC with AKD4370 by 10-line type flat cable (packed with AKD4370). Take care of
the direction of 10pin header. (Please install the driver in the CD-ROM when this control software is used on
Windows 2000/XP. Please refer âInstallation Manual of Control Software Driver by AKM device control softwareâ.
In case of Windows95/98/ME, this installation is not needed. This control software does not operate on Windows
NT.)
3. Insert the CD-ROM labeled âAK4370 Evaluation Kitâ into the CD-ROM drive.
4. Access the CD-ROM drive and double-click the icon of âakd4370.exeâ to set up the control program.
5. Then please evaluate according to the follows.
Operation flow
Keep the following flow.
1. Set up the control program according to explanation above.
2. Click âPort Resetâ button.
3. Click âWrite defaultâ button
Explanation of each buttons
1. [Port Reset] :
2. [Write default] :
3. [All Write] :
4. [Function1] :
5. [Function2] :
6. [Function3] :
7. [Function4] :
8. [Function5] :
9. [SAVE] :
10. [OPEN] :
11. [Write] :
Set up the USB interface board (AKDUSBIF-A) when using the board.
Initialize the register of AK4370.
Write all registers that is currently displayed.
Dialog to write data by keyboard operation.
Dialog to write data by keyboard operation.
The sequence of register setting can be set and executed.
The sequence that is created on [Function3] can be assigned to buttons and executed.
The register setting that is created by [SAVE] function on main window can be assigned to
buttons and executed.
Save the current register setting.
Write the saved values to all register.
Dialog to write data by mouse operation.
Indication of data
Input data is indicated on the register map. Red letter indicates âHâ or â1â and blue one indicates âLâ or â0â. Blank is
the part that is not defined in the datasheet.
<KM086300>
-9-
2006/12
|
▷ |