AKD5366 Datasheet, PDF (7/23 Pages) Asahi Kasei Microsystems – Evaluation board Rev.A for AK5366

ASAHI KASEI
[AKD5366]
2. Control Software Manual
„ Set-up of evaluation board and control software
1. Set up the AKD5366 according to previous term.
2. Connect IBM-AT compatible PC with AKD5366 by 10-line type flat cable (packed with AKD5366). Take care of
the direction of 10pin header. (Please install the driver in the CD-ROM when this control software is used on
Windows 2000/XP. Please refer “Installation Manual of Control Software Driver by AKM device control software”.
In case of Windows95/98/ME, this installation is not needed. This control software does not operate on Windows
NT.)
3. Insert the CD-ROM labeled “AK5366 Evaluation Kit” into the CD-ROM drive.
4. Access the CD-ROM drive and double-click the icon of “akd5366.exe” to set up the control program.
5. Then please evaluate according to the follows.
„ Operation flow
Keep the following flow.
1. Set up the control program according to explanation above.
2. Click “Port Setup” button.
3. Click “Write default” button.
4. Then set up the dialog and input data.
„ Explanation of each buttons
1. [Write default] :
2. [All Read] :
3. [Function2] :
4. [Write] :
5. [Read] :
Initialize the register of AK5366.
Read all registers of AK5366.
Dialog to evaluate IPGA.
Dialog to write data by mouse operation.
Read data by mouse operation.
„ Explanation of each dialog
1. [Function2 Dialog] : Dialog to evaluate IPGA
This dialog corresponds to only addr=04H, 05H.
Address Box: Input register address in 2 figures of hexadecimal.
Start Data Box: Input start data in 2 figures of hexadecimal.
End Data Box: Input end data in 2 figures of hexadecimal.
Interval Box: Data is written to AK5366 by this interval.
Step Box:
Data changes by this step.
Mode Select Box:
If you check this check box, data reaches end data, and returns to start data.
[Example] Start Data = 00, End Data = 09
Data flow: 00 01 02 03 04 05 06 07 08 09 09 08 07 06 05 04 03 02 01 00
If you do not check this check box, data reaches end data, but does not return to start data.
[Example] Start Data = 00, End Data = 09
Data flow: 00 01 02 03 04 05 06 07 08 09
If you want to write the input data to AK5366, click “OK” button. If not, click “Cancel” button.
<KM073600>
-7-
2004/05