AK6002A Datasheet, PDF (6/18 Pages) Asahi Kasei Microsystems – I2C BUS 2K/4K/16K BIT SERIAL CMOS EEPROM

ASAHI KASEI
Pin Descriptions
SCL(Serial Clock)
The SCL input is used to clock all data into and out of the device.
[AK6002A/04A/08A]
SDA(Serial Data)
The SDA is a bidirectional pin used to transfer data into and out of the device.
It is an open drain output and may be wire-ORed with any number of open drain or open collector
outputs.
SO,S1,S2(Device Address)

AK6002A, AK6004A
The S0, S1 and S2 are device address inputs that are used to set two or three bits of the slave
address.
AK6002A



A total of eight devices can be connected to the same bus.
AK6004A



A total of four devices can be connected to the same bus.
WC (Write Control)
AK6002A / 04A

If the WC is High level, WRITE operations will not be executed. If the WC is
Low level, the AK6004A will be enabled to perform WRITE operation.
AK6008A



If the WC is High level, WRITE operations onto the upper half of the memory
(400
7FF(Hex)) will not be executed. If the WC is Low level, the AK6008A will
be enabled to perform WRITE operation.
As the WC is internally pulled down to GND, the AK6002A/04A/08A will be enabled to perform
WRITE operation if the WC is left floating.
WC must not change from the start condition input to the stop condition input.
VCC(Power Supply)
GND(Ground)
DAI01E-01
-6-
1999/10