AK8130A Datasheet, PDF (5/8 Pages) Asahi Kasei Microsystems – Low Power Multiclock Generator with VCXO

The brand name
of AKEMD’s IC’s
AK8130A
Output clock frequency selection
The AK8130A generates a range of low-jitter and hi-accuracy clock frequencies with three built-in PLLs and
provides to up to four assigned outputs. A frequency selection at assigned output pin is configured by
pin-setting of S0 (Pin2), S1 (Pin3), and S2 (Pin14).
The selectable frequency is shown in Table 1..
Table 1: Clock output Frequency
Selection Pin
S2
(Pin 14)
L
L
L
L
H
H
H
H
S1
(Pin 3)
L
L
H
H
L
L
H
H
S0
(Pin 2)
L
H
L
H
L
H
L
H
CLK1
(Pin 7)
74.250
74.250
74.1758
74.1758
74.1758
74.1758
74.1758
54.000
Clock Output Frequency (MHz)
CLK2
(Pin 8)
25.000
25.000
25.000
25.000
25.000
25.000
25.000
OFF
CLK3
(Pin 10)
48.000
12.000
48.000
12.000
OFF
4.9152
4.9152
4.9152
CLK4
(Pin 11)
33.333
OFF
33.333
OFF
33.333
OFF
24.576
24.576
Voltage Control Crystal Oscillator (VCXO)
The AK8130A has a voltage control crystal oscillator (VCXO), featuring fine frequency tuning for 27MHz of
primary clock frequency by external DC voltage control. This tuning enables output clock frequency to
synchronize the external clock system. VIN (Pin 4) accepts DC voltage control from a processor or a
system controller, and pulls the primary frequency of crystal to higher or lower. This pulling range is
determined by crystal characteristic, on-chip load capacitor, and stray capacitance of PCB. The AK8130A
is designed to range ±110ppm of primary frequency in AKEMD’s authorized condition, and the typical
pulling profile is shown in Figure 1. For details about the condition and other specific crystal application
case, refer the AK8130 Family application note.
150.0
27.0MHz VCXO Characteristics NDK NX5032GA （CL=8.0pF）
(Cext1=12.0pF, Cext2=1.0pF)
100.0
50.0
0.0
0
0.5
1
1.5
2
2.5
3
3.5
-50.0
-100.0
-150.0
V IN(V )
Figure 1: Typical VCXO Pulling Profile
MS0597-E-02
-5-
Feb-08