AKD5359 Datasheet, PDF (3/24 Pages) Asahi Kasei Microsystems – AK5359 Evaluation Board Rev.0

ASAHI KASEI
[AKD5359-B]
(2) Master Mode
(2-1) A/D evaluation using DIT function of AK4114
PORT2 (DIT) is used. DIT generates audio bi-phase signal from received data and which is output through
optical connector (TOTX141). It is possible to connect AKM’s D/A converter evaluation boards on the
digital-amplifier, which equips DIR input. Nothing should be connected to PORT1 (DSP). The DIF1 of SW1
(MODE) should be set to “H”.
JP5
MCLK
(2-2) Master clock is fed externally.
PORT1 (DSP) is used. MCLK is provided to the AK5359 through PORT1. JP5 (MCLK) should be open. The
DIF1 of SW1 (MODE) should be set to “H”.
JP5
MCLK
„ Other jumper pins set up
1. JP1 (GND) : Analog ground and Digital ground
OPEN : Separated.
SHORT : Common. (The connector “DGND” can be open.) <Default>
2. JP2 (CKS1) : Setting of CKS1 pin for AK5359
H : Master mode
L : Slave mode <Default>
3. JP3 (VA) : Select VA for AK5359
VA : Supply from VA connector
REG : Supply from regulator. VA connector should be supplied +15V. <Default>
4. JP4 (VD) : Select VD for AK5359
VA : Supply from VA connector
VD : Supply from VD connector <Default>
<KM079700>
-3-
2005/07