AK8963C Datasheet, PDF (23/38 Pages) Asahi Kasei Microsystems – 3-axis Electronic Compass

[AK8963]
7.2.1.3. Acknowledge
The IC that is transmitting data releases the SDA line (in the "High" state) after sending 1-byte data.
The IC that receives the data drives the SDA line to "Low" on the next clock pulse. This operation is referred as
acknowledge. With this operation, whether data has been transferred successfully can be checked.
AK8963 generates an acknowledge after reception of a start condition and slave address.
When a WRITE instruction is executed, AK8963 generates an acknowledge after every byte is received.
When a READ instruction is executed, AK8963 generates an acknowledge then transfers the data stored at the
specified address. Next, AK8963 releases the SDA line then monitors the SDA line. If a master IC generates
an acknowledge instead of a stop condition, AK8963 transmits the 8bit data stored at the next address. If no
acknowledge is generated, AK8963 stops data transmission.
Clock pulse
for acknowledge
SCL FROM
MASTER
1
8
9
DATA
OUTPUT BY
TRANSMITTER
DATA
OUTPUT BY
RECEIVER
START
CONDITION
not acknowledge
acknowledge
Figure 7.5 Generation of Acknowledge
7.2.1.4. Slave Address
The slave address of AK8963 can be selected from the following list by setting CAD0/1 pin. When CAD pin is
fixed to VSS, the corresponding slave address bit is “0”. When CAD pin is fixed to VDD, the corresponding
slave address bit is “1”.
Table 7.1 Slave Address and CAD0/1 pin
CAD1
CAD0
Slave Address
0
0
0CH
0
1
0DH
1
0
0EH
1
1
0FH
MSB
0
0
LSB
0
1
1 CAD1 CAD0 R/W
Figure 7.6 Slave Address
The first byte including a slave address is transmitted after a start condition, and an IC to be accessed is
selected from the ICs on the bus according to the slave address.
When a slave address is transferred, the IC whose device address matches the transferred slave address
generates an acknowledge then executes an instruction. The 8th bit (least significant bit) of the first byte is a
R/W bit.
When the R/W bit is set to "1", READ instruction is executed. When the R/W bit is set to "0", WRITE
instruction is executed.
MS1356-E-02
- 23 -
2013/10