AKD4363 Datasheet, PDF (22/30 Pages) Asahi Kasei Microsystems – EVALUATION BOARD REV.A FOR AK4363

ASAHI KASEI
[AKD4363 Control Program]
AKD4363 Control Program ver 2.0 operation manual
1. Connect IBM-AT compatible PC with AKD4363 by 10-line type flat cable (packed with AKD4363).
Take care of the direction of 10pin Header (Refer to manual of AKD4363).
2. Start up “WINDOWS 95” or “WINDOWS 98”.
3. Insert the floppy-disk labeled “AKD4363 Control Program ver 2.0” into the floppy-disk drive.
4. Set up “MS-DOS” from start menu.
5. Change directory to the floppy-disk drive(ex.a:) at MS-DOS prompt.
6. Type “ak4363”.
7. Then follow the displayed comment (See the following).
==================== <<Operating flow>> =====================
Input Control Mode (3-wire serial or I2C bus)
Input Chip Address (2bit)
Write data/ Display register map/ Reset etc.à loop
=========================================================
‘00/2
-1-