AKD5358 Datasheet, PDF (2/20 Pages) Asahi Kasei Microsystems – AK5358 Evaluation Board Rev.0

ASAHI KASEI
[AKD5358-B]
1. Evaluation Board Manual
„ Operation sequence
1) Set up the power supply lines.
[VA] (red) = 2.7 ∼ 5.5V or +15V : for VA of AK5358 (typ. 5.0V)
[VD] (orange) = 2.7 ∼ 5.5V
: for VD of AK5358, 74HC14 (typ. 5.0V)
[VCC] (red) = 3.3V
: for AK4114
[AGND] (black) = 0V
: for analog ground
[DGND] (black) = 0V
: for logic ground
Each supply line should be distributed from the power supply unit.
2) Set up the evaluation mode, jumper pins and DIP switches. (See the followings.)
3) Power on.
The AK5358 and AK4114 should be reset once bringing SW2 = “L” upon power-up.
„ Evaluation mode
(1) Slave Mode
(1-1) A/D evaluation using DIT function of AK4114
PORT2 (DIT) is used. DIT generates audio bi-phase signal from received data and which is output through
optical connector (TOTX141). It is possible to connect AKM’s D/A converter evaluation boards on the
digital-amplifier, which equips DIR input. Nothing should be connected to PORT1 (DSP).
JP5
MCLK
(1-2) All interface signals including master clock are fed externally.
PORT1 (DSP) is used. All interface signals (MCLK, SCLK, LRCK) are provided to the AK5358 through
PORT1. JP5 (MCLK) should be open. The DIF1 of SW1 (MODE) should be set to “H”.
JP5
MCLK
<KM079501>
-2-
2005/09