AKD4395 Datasheet, PDF (2/25 Pages) Asahi Kasei Microsystems – EVALUATION BOARD REV.C FOR AK4395

ASAHI KASEI
[AKD4395]
<External Analog Circuit (Rev.C)
The differential output circuit and LPF is implemented on board. The differential outputs of AK4395 is buffered by non-inverted
circuit and output via Cannon connector(differential output). LPF adds differential outputs. NJM5534D is used for op-amp on this
board that has low noise and high voltage torelance characteristics. Analog signal is output via Cannon and BNC connectors on
the board. The output level is about 2.73Vrms (typ@VREF=5.0V) by Cannon and 2Vrms (typ@VREF=5.0V) by BNC.
100u
AOUTL- ⁺
300
6.8n
300
6.8n
37
2
+
-4
6
NJM5534D
200
+
0.1u
+
0.1u
10u
10u
100u
AOUTL+ ⁺
300
6.8n
300
6.8
+ _10u
37
0.1u
2
+
-
6
4
NJM5534D
10u
+
0.1u
200
3
2
1
+15
-15
620
620
470
0.1u +^10u
.2.2n
2 _- 4 ₆ ¹⁰⁰
3+7
Lch
2.2n NJM5534D
0.1u
+_10u
Fig.2 External Analog Filter
<Operation sequence
1. Set up the jumpers for power supply.
[JP15(REG)] selects power supply for AVDD pin of AK4395.
short: 5V is supplied from regulator. (default)
Nothing should be connected to A5V jack.
open: 5V is supplied from A5V.
2. Set up the power supply lines.
+15V=15V, -15V=-15V: Power supply for op-amp. AVDD of AK4395 is supplied from “+15V” through
regulator (JP15: short).
A5V=5V:
This jack is used when AVDD of AK4395 is supplied from this. In this case, JP15
should be open.
DVDD=5V:
Power supply for logic circuit on this board.
VP=3V∼5.25V:
Digital (set JP10 to VP),
AGND=DGND=0V .
Each supply line should be distributed from the power unit.
3. Set up the evaluation modes by jumper pins and DIP switches.(See next item.)
4. Power on.(The AK4395 should be reset once by bringing PD "L" upon power-up.)
*SW1 resets the AK4395 during operation.
The AK4395 is reset at SW1="L" and exits resetting at SW1="H".
<KM063300>
2
2000/7