AKD4626A-B Datasheet, PDF (15/44 Pages) Asahi Kasei Microsystems – Multi-channel Audio CODEC.

ASAHI KASEI
[AKD4626A-B]
AK4112B Control Program ver 1.0 operation manual
„ Set-up of evaluation board and control software
This board is used AK4112B as “DIR”. This software must set up when Evaluation of DAC using DSP and
Clock Mode selected X’tal.(See P3. (4)).
This evaluation board does not correspond to I²C control.
1. Set up the AKD4628 according to above mentioned setting.
2. Connect IBM-AT compatible PC with AKD4628 by 10-line type flat cable (packed with AKD4628). Take care of
the direction of 10pin header. (Please install the driver in the CD-ROM-disk when this control software is used on
Windows 2000/XP. Please refer “Installation Manual of Control Software Driver by AKM device control software”.
In case of Windows95/98/ME, this installation is not needed. This control software does not operate on Windows
NT.)
3. Insert the CD-ROM-disk labeled “AKD4628 Control Program ver 1.0” into the CD-ROM-disk drive.
4. Access the CD-ROM-disk drive and double-click the icon of “akd4112.exe” to set up the control program.
5. Then please evaluate according to the follows.
„ Operation flow
Keep the following flow.
1. Set up the control program.
2. Click “Port Setup” button.
3. Then set up the dialog and input data.
„ Explanation of each buttons
1. [Port Setup] : set up the printer port.
2. [Write default] : initialize the register of AK4112B.
3. [All read] :
read all registers of AK4112B.
4. [Read] :
read data from each register.
5. [Write] :
write data to each register.
If you want to write the input data to AK4112B, click “OK” button. If not, click “Cancel” button.
„ Indication of data
Input data is indicated on the register map. Red letter indicates “H” or “1” and blue one indicates “L” or “0”. Blank is the
part that is not defined in the datasheet.
<KM079800>
- 15 -
2005/11