AMLD-Z_16 Datasheet, PDF (6/13 Pages) AIMTEC – Up to 1000mA | LED Driver

Series AMLD-Z
Up to 1000mA | LED Driver
Output Current Adjustment by PWM Control:
Driving VADJ Directly
A Pulse Width Modulation (PWM) signal with a duty cycle DPWM can be applied to the ADJ pin as shown below.
The output current is given by:
Iout ≈ _{Ioutnom x DPWM} ^{[if PWM frequency < 300Hz,}
for 0.1<DPWM<1]
1.25V ^{PWM VADJ}
0V
GND
AMLD-Z
-Vin
+Vout
1^st LED
1
-Vout
Last LED
1
Driving VADJ Via Open Collector Transistor
The VADJ can also be driven via an open collector transistor as shown below.
The diode and resistor serve to suppress any possible high amplitude negative voltage spikes to the VADJ input resulting
from the collector to emitter capacitance of the transistor. Any negative voltage spikes will cause errors in output current
and/or unstable driver operation.
PWM
1.25V
0V
GND
VADJ
3.3K
1
AMLD-Z
-Vin
+Vout
-Vout
1^st LED
1
Last LED
1
www.aimtec.com
F 051e R12.G
Tel: [phone]
6 of 13
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only