AM1L-0505D-NZTR Datasheet, PDF (3/6 Pages) AIMTEC – 1 Watt | DC-DC Converter

Series AM1L-NZ
1 Watt | DC-DC Converter
Output Specifications (continued)
Parameters
Conditions
Typical
Maximum
Units
Load voltage regulation (Single)
Load 10 – 100%
10
%
Load voltage regulation (Dual)
Load 10 – 100%
10
%
Load voltage regulation (Dual Separated)
Temperature coefficient
Load 10 – 100%
12.8
±0.03
%
%/^oC
Ripple & Noise
At 20MHz Bandwidth
75
100
mV p-p
If the operating output current is less than 10% of maximum it is recommended to install a load resistor in parallel with the
load to ensure the actual load current meets the minimum load current requirement.
General Specifications
Parameters
Switching frequency
Max Case temperature
Operating temperature
Storage temperature
Cooling
Humidity
Case material
Weight
Dimensions (L x W x H)
MTBF
Conditions
Typical
Maximum
Units
100% load
100
KHz
+95
o_C
Without derating
-40 to +85
o_C
-55 to +125
o_C
Free air convection
95
%
Plastic UL94-VO
1.5
Dual Separated
2.1
g
Single 1000VDC
0.50 x 0.44 x 0.25 inch 12.70 x 11.20 x 6.25 mm
Dual 1000VDC
0.60 x 0.44 x 0.25 inch 15.24 x 11.20 x 6.25 mm
Dual Separated 1000VDC
0.70 x 0.70 x 0.24 inch 17.78 x 17.78 x 6.00 mm
Single and Dual 3000VDC
0.6 x 0.44 x 0.26 inch 15.24 x 11.20 x 6.50 mm
>980 000 hrs single, 1 000 000hrs dual (MIL-HDBK -217F, Ground Benign, t=+25^oC)
Safety Specifications
Parameters
cULus (for 3000VDC Isolated models and 5 and 12 Vin models with 1000VDC Isolation,
Agency approvals AM1L-0303S-NZ and AM1L-0305S-NZ )
CE (for 5 and 12 Vin single models)
Standards
IEC 60950-1 2001
www.aimtec.com
F 051e R8.I
Tel: [phone]
3 of 6
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only