AM1DS-NZ Datasheet, PDF (3/3 Pages) AIMTEC – 1 Watt | DC-DC Converter

Series AM1DS-NZ
1 Watt | DC-DC Converter
General Specifications (continued)
Parameters
Conditions
Typical
Maximum
Dimensions (L x W x H)
MTBF
0.77 x 0.24 x 0.37 inches 19.5 x 6.00 x 9.35 mm
>1 940 000 hrs (MIL-HDBK -217F, Ground Benign, t=+25^oC)
Maximum soldering temperature 1.5 mm from case for 10sec
300
Units
o_C
Pin Out Specifications
Pin
1000 VDC
Single
Dual
1
+ V Input + V Input
2
- V Input
- V Input
4 - V Output - V Output
5
No pin
Common
6 + V Output + V Output
7
No pin
No pin
3000VDC
Single
Dual
+ V Input
+ V Input
- V Input
- V Input
No pin
No pin
- V Output - V Output
No pin
Common
+ V Output + V Output
Dimensions
19.50
(0.76)
9.50
(0.37)
6.00
(0.24)
PRINTED
FACE
9.50
(0.37)
0.50
(0.02)
2.54
(0.10) _15.20
(0.60)
6.00
(0.24)
1.25
(0.05)
0.50
(0.02)
4.10
(0.16)
0.50
(0.02)
NOTE: Unit:mm [inch]
Pin tolerances: 0.10mm [ 0.004inch]
General tolerances: 0.25mm [ 0.010inch]
0.25
(0.01)
NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the
date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%,
nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components
and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This
product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate
specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com.
www.aimtec.com
F 051e R12.B
Tel: [phone]
3 of 3
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only