AMLDP-Z Datasheet, PDF (2/18 Pages) AIMTEC – Up to 1000mA | LED Driver

Series AMLDP-Z
Up to 1000mA | LED Driver
General Specifications (continued)
Parameters
Conditions
Typical
Maximum
Weight
1.8
Dimensions (L x W x H)
MTBF
0.50 x 0.40 x 0.27 inches 12.70 x 10.16 x 6.85 mm
> 3,300,000 hrs (MIL-HDBK-217 F at +25 ^oC)
Maximum soldering temperature
1.5mm from case for 10sec
260
Units
g
o_C
NOTES:
1.Reversed polarity at the input power will damage the driver. The input ground must not be connected to the negative output.
2.Leave the pin VADJ opened if not used , grounding VADJ will shut the driver off, connecting VADJ to +Vin will damage the driver.
3.Maximum output open voltage is equal to input voltage
Safety Specifications
Parameters
Agency Approvals
CE
EN55015: 2007+A2: 2009
EN61547: 2009
IEC 61000-4-2: 2008
IEC 61000-4-3: 2006+A1: 2007+A2: 2010
Standards
IEC 61000-4-4: 2004+A1: 2010
IEC 61000-4-5: 2005
IEC 61000-4-6: 2008
IEC 61000-4-8: 2009
IEC 61000-4-11: 2004
NOTE: also designed to meet EN609501
Pin Out Specifications
Pin
Single
1
+ V Input
+ DC Supply
4
+ V Output LED Anode connection
5
- V Output
LED Cathode connection
7
Vadj
PWM/ON/OFF or not used
8
- V Input
- DC Supply
Dimensions
12.70
(0.50)
0.50
(0.02)
7.62
(0.30)
10.16
(0.40)
7.62
(0.30)
1
4
Bottom View
87
5
6.85
(0.27)
3.05
(0.12)
www.aimtec.com
F 051e R12.C
2.54
(0.10)
2.54
(0.10)
0.50
(0.02)
NOTES: All dimensions are in millimeters (inch)
Pin Diameter: 0.5 ± 0.05 (0.02 ± 0.002)
Pin Pitch Tolerance: ± 0.35 (± 0.014)
Case Tolerance: ± 0.5 (± 0.02)
Tel: [phone]
2 of 18
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only