AMLDLW-Z_13 Datasheet, PDF (2/12 Pages) AIMTEC – Up to 1000mA | LED Driver

Series AMLDLW-Z
Up to 1000mA | LED Driver
General Specifications (continued)
Parameters
Conditions
Typical
Maximum
Humidity
95
Case material
Non-Conductive Black Plastic (UL94-V0 rated)
Weight
6.2
Dimensions (L x W x H)
MTBF
0.92 x 0.55 x 0.40 inches
23.40 x 14.00 x 10.16 mm
> 500 000hrs (MIL-HDBK-217 F at +25 ^oC)
Maximum Soldering Temperature
1.5mm from case for 10sec.
260
NOTES:
1.Reversed polarity at the input power will damage the driver. The input ground must not be connected to the negative output.
2.Leave the pin VADJ opened if not used , grounding VADJ will shut the driver off, connecting VADJ to +Vin will damage the driver.
3.Maximum output open voltage is equal to input voltage
Units
% RH
g
o_C
Safety Specifications
Parameters
Agency approvals
Standards
CE, EN 55015, EN 61547
Electrostatic Discharge Immunity
RF, Electromagnetic Field Immunity
Electrical Fast Transient/Burst Immunity
Surge Immunity
RF, Conducted Disturbance Immunity
Power frequency Magnetic Field Immunity
Voltage dips, Short Interruptions Immunity
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-4
IEC 61000-4-5
IEC 61000-4-6
IEC 61000-4-8
IEC 61000-4-11
Pin Out Specifications
Pin
Single
Description
1(Black) - V Input
- DC Supply
2(White) Vadj
PWM/ON/OFF or not used
8(Blue) -V Output
LED Cathode Connection
9(Yellow) + V Output
LED Anode connection
16 (Red) + V Input
+ DC Supply
www.aimtec.com
F 051e R9.D
Tel: [phone]
2 of 12
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only