AMLDL-Z Datasheet, PDF (2/14 Pages) AIMTEC – Up to 1000mA | LED Driver

Series AMLDL-Z
Up to 1000mA | LED Driver
General Specifications (continued)
Parameters
Maximum case temperature
Thermal Impedance
Conditions
Free air convection
Typical
+40
Maximum
100
Units
o_C
o_C/W
Cooling
Free air convection
Humidity
95
% RH
Case material
Non-Conductive Black Plastic (UL94-V0 rated)
Weight
2.6 (DIP14)
6.2 (DIP 16)
g
Dimensions (L x W x H)
MTBF
Maximum Soldering Temperature
DIP 14
0.80 x 0.40 x 0.27 inches
20.32 x 10.16 x 6.88 mm
DIP 16
0.80 x 0.40 x 0.40 inches
23.37 x 13.97 x 10.16 mm
> 500 000hrs (MIL-HDBK-217 F at +25 ^oC)
1.5mm from case for 10sec.
260
o_C
NOTES:
1.Reversed polarity at the input power will damage the driver. The input ground must not be connected to the negative output.
2.Leave the pin VADJ opened if not used , grounding VADJ will shut the driver off, connecting VADJ to +Vin will damage the driver.
3.Maximum output open voltage is equal to input voltage
Safety Specifications
Parameters
Agency approvals
CE
EN 55015 (CISPR22)
IEC 61000-4-2 (Perf. Criteria A)
Standards
IEC 61000-4-3 (Perf. Criteria A)
IEC 61000-4-4 (Perf. Criteria A)
IEC 61000-4-6 (Perf. Criteria A)
IEC 61000-4-8 (Perf. Criteria A)
Pin Out Specifications
DIP 14
Pin
Single
1
- V Input
- DC Supply
2
Vadj
PWM/ON/OFF or not used
7
- V Output
LED Cathode connection
8
+ V Output
LED Anode connection
14
+ V Input
+ DC Supply
Derating
Free Air Convection
DIP 16
Pin
Single
1
- V Input
2
- V Input
3
Vadj
7
- V Output
8
- V Output
9
+ V Output
10
+ V Output
15
+ V Input
16
+ V Input
- DC Supply
- DC Supply
PWM/ON/OFF or not used
LED Cathode connection
LED Cathode connection
LED Anode connection
LED Anode connection
+ DC Supply
+ DC Supply
100
80
60
Safe Operating Area
40
20
0
- 40 - 20 0
20
40
60 ⁷¹ 80 ⁸⁵ 100
Ambient Temperature º C
AMLDL-3030Z
AMLDL-3035Z
AMLDL-3050Z
AMLDL-3060Z
AMLDL-3070Z
AMLDL-301000Z
www.aimtec.com
F 051e R9.G
Tel: [phone]
2 of 14
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only