AMLBW-3625Z Datasheet, PDF (2/8 Pages) AIMTEC – Step Up LED Driver

Series AMLBW-Z
Up to 700mA | Step Up LED Driver
General Specifications
Parameters
Operating frequency
Conditions
Depending on the model
AMLBW-3615Z
Typical
360-380
-40 to +85
Maximum
Units
KHz
Operating temperature
AMLBW-3625Z; AMLBW-3630Z -40 to +80 (Vin 9-18V) / -40 to +85 (Vin 18-36V)
AMLBW-3635Z
-40 to +75 (Vin 9-18V) / -40 to +85 (Vin 18-36V)
o_C
AMLBW-3650Z
-40 to +70 (Vin 9-18V) / -40 to +80 (Vin 18-36V)
AMLBW-3660Z; AMLBW-3670Z -40 to +70 (Vin 9-18V) / -40 to +75 (Vin 18-36V)
Storage temperature
Maximum case temperature
Thermal Impedance
Depending on the model
-55 to +125
+13.7 to +17
o_C
100
o_C
o_C/W
Cooling
Free air convection
Humidity
95
% RH
Case material
Non-Conductive Black Plastic (UL94-V0 rated)
Weight
38
g
Dimensions (L x W x H)
2.03 x 1.03 x 0.62 inches
51.50 x 26.10 x 15.80 mm
MTBF
> 860 000hrs (MIL-HDBK-217 F at +25 ^oC/Vin=9V,Vout=38V)
Maximum Soldering Temperature 1.5mm from case for 10sec.
260
o_C
NOTES:
1. To prevent burning out the driver, the output voltage must be 5.0VDC higher than the input voltage
2. Do NOT exceed the maximum power ratings on each model
3. With output ripple being rather low, it is recommended not to increase the additional output capacitor so s not to increase the delay while starting up
under cool start conditions
4. This series offers protection in case the output is shorted. After the short occurs, thDe input current will be cut off and recovers when the short is removed
5. The reference value of under voltage protection (7.6V) means that under the condition of cool start and full discharge of output, the protection starts when
input voltage is lower than 7.6V
6. Note: PWM dimming means PWM signals are converted into mimic analog voltage by internal circuits and then do the dimming. The advantage of this
approach is to reduce the EMI
Safety Specifications
Parameters
Standards
EMI: Designed to meet EN 55022 Class B
Safety : Designed to meet IEC/EN 60950-1 , UL8750, IEC/EN 61347-2-13
Pin Out Specifications
Pin
1(Red)
2(White)
3(Blue)
4(Black)
5(Yellow)
6(Black)
Single
+Vi
DIM
EN
-Vi
+LED
-LED
+ DC Supply
PWM/Analog Dimming Control
Remote ON/OFF
-DC Supply
LED Anode connection
LED Cathode connection
www.aimtec.com
F 051e R12.B
Tel: [phone]
2 of 8
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only