AMEL5-MAZ-1_16 Datasheet, PDF (2/5 Pages) AIMTEC – 5 Watt | AC-DC / DC-DC Converter

Series AMEL5-MAZ
Output Specifications
5 Watt | AC-DC / DC-DC Converter
Parameters
Conditions
Typical
Voltage accuracy
±2
Line regulation
±1
Load regulation (single output)
0-100% load
±1
Cross Regulation (dual output)
25% load – 1^st out, 100% load – 2^nd out
±5
Transient Recovery Time
300
Transient Response Deviation
25% load step
±2
Minimum load
0
Ripple & Noise *
3.3 / 5V models
75
12 / 15V models
100
24V
150
Hold-up time (minimum)
15
*Ripple and Noise are measured at 20MHz bandwidth by using a 0.1µF (M/C) and 47µF (E/C) parallel capacitor.
Maximum
Units
%
%
%
%
µs
% of Vout
%
mV p-p
ms
Isolation Specifications
Parameters
Tested I/O voltage
Isolation Resistance
Conditions
60 sec
Typical
4000
>1000
Rated
Units
VAC
MΩ
General Specifications
Parameters
Conditions
Typical
Maximum
Units
Switching frequency
132
KHz
Protection class
Class II
Over Load protection
Fold back
Over voltage protection
Zener diode clamp
Short circuit protection
Auto recovery
Operating temperature
With derating above 50ºC
Refer to the models table above
o_C
Storage temperature
-40 to +95
o_C
Maximum Case temperature
100
o_C
Temperature coefficient
0.02
% / ^oC
Cooling
Free air convection
Humidity
Non condensing
20 ~ 95
% RH
Case material
Plastic (flammability to UL 94V-0)
Weight
30
g
Dimensions (L x W x H)
2.03 x 1.10 x 0.70 inches 51.5 x 28 x 17.8mm
MTBF
> 400,000 hrs (MIL-HDBK -217F, t=+25^oC)/Full Load
> 100,000 hrs (MIL-HDBK -217F, t=at highest operating temperature)/Full Load
NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at
rated output load unless otherwise specified.
Environment Approval
Parameters
Wave form: Half sine wave
Conditions
Acceleration amplitude: 5gn
Shock
Bump duration: 30 ms
Number of bumps: 18 (3 in each direction for every axis)
Converter operation before and after test, body mounted (on chassis)
Test mode: Sweep sine
10-100Hz, speed 0.05Hz/s
Vibrations
Displacement: 1mm
Acceleration: 3g
3 loops 30min one cycle, 3h total, every axis tested
Converter operation before and after test, body mounted (on chassis)
www.aimtec.com
F 052e R8.R
Tel: [phone]
2 of 5
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only