AM15EW-C Datasheet, PDF (1/2 Pages) AIMTEC – 15 watt dc-dc converters

AM15EW-C Series
15 watt dc-dc converters
• ^{POWER MODULES FOR PCB MOUNTING}
• ^{4:1 WIDE INPUT RANGE}
• ^{REGULATED OUTPUT}
• ^{LOW RIPPLE & NOISE}
• ^{REMOTE ON/OFF CONTROL (OPTIONAL)}
GENERAL DESCRIPTION
Our AM15EW-C series is a family of cost effective 15W single
output DC-DC converters. These converters are shielded on
all six sides and encapsulated with a nickel-coated copper
with a non-conductive base and dimensions of
50.8x25.4x10.5mm. The high performance features of
our AM15EW-C components include short circuit protec-
tion with current limit auto recovery, tight line regulation
and a high efficiency operation coefficient up to 83%.
These wide range devices operate over 4:1 input voltage
range, providing a continuously stable output voltage.
Ten models operate from an input voltage range of 24 &
48VDCproducing output voltages of 3,3, 5, 12, 15 &
24VDC. The normal operation is specified over the full
operating temperature range of -25°C to +71°C with no
derating required. Cooling is done by free air convection.
ELECTRICAL SPECIFICATIONS
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
Input Specifications:
Voltage range
Filter
24VDC, 9~36VDC
48 VDC, 18~75VDC
p (Pi) Network
Isolation Specifications:
Rated voltage
Resistance
Capacitance
1500VDC
>1000 Mohms
1000pF
General Specifications:
Efficiency
Switching frequency
79% to 83%
300KHz, typ. 100% load
Environmental Specifications:
Operating temperature
-25°C …+71°C
Storage temperature
-55°C …+105°C
Case temperature
+95°C, max.
Humidity (non-condensing) Up to 95%
Cooling
Free-air convection
Output Specifications:
Voltage accuracy
±2%, max.
Ripple
<0.2% Vout +20mVmax (Vp-p)
Noise
<0.5% Vout +50mVmax (Vp-p)
Short circuit protection Current limit, auto-recovery
Over current protection Works over 120% of rating
and recovers automatically
Over voltage protection Zener diode clamp protection
Line regulation (HL-LL) ±0.5%, typ.
Load regulation (10-100%) ±1%, typ.
Temperature coefficient ±0.02%/°C, typ.
Physical Specifications:
Dimensions
50.8x25.4x10.5mm
2.0x1.0x0.413inches
Weight
32g
Case material
Nickel-Coated Copper with
Non-Conductive base,
six sides’ shielded
MTBF: > 800,000 hrs (MIL-HDBK-217F, Ground Benign, t=+25ºC)
Specifications are subject to change without notification
80 _{Continued on next page}
TO ORDER CALL 1-888-9-AIMTEC