FW802BF Datasheet, PDF (1/26 Pages) Agere Systems – Low-Power PHY 1394a-2000 Two-Cable Transceiver/Arbiter Device

FW802BF Low-Power PHY 1394a-2000
Two-Cable Transceiver/Arbiter Device
Data Sheet
January 2005
™
™
Distinguishing Features
„ Compliant with IEEE^® Standard 1394a-2000,
IEEE Standard for a High Performance Serial
Bus Amendment 1.
„ Low power consumption during powerdown or
microlow-power sleep mode.
„ Supports extended BIAS_HANDSHAKE time for
enhanced interoperability with camcorders.
„ While unpowered and connected to the bus, will not
drive TPBIAS on a connected port even if receiving
incoming bias voltage on that port.
„ Does not require external filter capacitors for PLL.
„ Does not require a separate 5 V supply for 5 V link
controller interoperability.
„ Interoperable across 1394 cable with 1394 physical
layers (PHY) using 5 V supplies.
„ Interoperable with 1394 link-layer controllers using
5 V supplies.
„ 1394a-2000 compliant common mode noise filter
on incoming TPBIAS.
„ Powerdown features to conserve energy in battery-
powered applications include the following:
— Device powerdown ball.
— Link interface disable using LPS.
— Inactive ports power down.
— Automatic microlow-power sleep mode during
suspend.
„ Interface to link-layer controller supports Annex J
electrical isolation as well as bus-keeper isolation.
Features
„ Provides two fully compliant cable ports at
100 Mbits/s, 200 Mbits/s, and 400 Mbits/s.
„ Fully supports 1394 Open HCI requirements.
„ Supports arbitrated short bus reset to improve
utilization of the bus.
„ Supports ack-accelerated arbitration and fly-by con-
catenation.
„ Supports connection debounce.
„ Supports multispeed packet concatenation.
„ Supports PHY pinging and remote PHY access
packets.
„ Fully supports suspend/resume.
„ Supports PHY-link interface initialization and reset.
„ Supports 1394a-2000 register set.
„ Supports LPS/link-on as a part of PHY-link inter-
face.
„ Supports provisions of IEEE 1394-1995 Standard
for a High Performance Serial Bus.
„ Fully interoperable with FireWire^® and i.LINK ^®
implementations of IEEE 1394-1995.
„ Reports cable power fail interrupt when voltage at
CPS ball falls below 7.5 V.
„ Provides separate cable bias and driver termination
voltage supply for each port.
Other Features
„ 48-ball VTFSBGAC package.
„ Single 3.3 V supply operation.
„ Data interface to link-layer controller provided
through 2/4/8 parallel lines at 50 Mbits/s.
„ 25 MHz crystal oscillator and PLL provide a 50 MHz
link-layer controller clock as well as transmit/receive
data at 100 Mbits/s, 200 Mbits/s, and 400 Mbits/s.
„ Multiple separate package signals provided for ana-
log and digital supplies and grounds.
Description
The Agere Systems FW802BF device provides the
analog physical layer functions needed to imple-
ment a two-port node in a cable-based IEEE 1394-
1995 and IEEE 1394a-2000 network.
Each cable port incorporates two differential line
transceivers. The transceivers include circuitry to
monitor the line conditions as needed for determin-
ing connection status, for initialization and
arbitration, and for packet reception and transmis-
sion. The PHY is designed to interface with a link-
layer controller (LLC).