CT1469-2 Datasheet, PDF (5/10 Pages) Aeroflex Circuit Technology – CT1469-2 MIL-STD-1397 Type E 10MHz Transceiver

Transmitter Timing Characteristics (con’t)
(VCC = 5V ±10%, VEE = -5V ±10%, TC = -55 °C to +100°C, See Figure 2 and 3, unless otherwise specified)
Symbol Parameter / Condition
Min Max
VS
VUS
TOS
TDTX
VN
Zo
Inhibit
Voltage overshoot
Voltage undershoot
Offset Voltage – 2T after last zero crossing
Delay from data input to transformer secondary
Transmitter noise output with transmitter inhibited
Output impedance
External-TTL low inhibits outputs
Internal-Equal input signals inhibit output
- 100
- 100
-
30
-
50
-
35
45 55
1. Pins 25 and 27 are not used for MIL-STD-1397 Type E nominal output signal levels.
Unit
mV
mV
mV
nsec
mV
Ω
Receiver Timing Characteristics
(VCC = 5V ±10%, VEE = -5V ±10%, TC = -55 °C to +100°C, See Figure 4, unless otherwise specified)
Symbol Parameter / Condition
VIN Input signal to receiver
VCM Common Mode Rejection
DC to 1.0MHz
2.0MHZ to 20MHz
VT Signal rejection
No response to single ended signals
TD1
TD2
VO
TRSU
TRSH
Strobe
Delay from 50% point of positive input
signal to 50% point of data output
Delay from 50% point of negative input
signal to 50% point of data output
Output signal
Complementary TTL drive capability
of 2 TTL Loads
To input data, setup time Receiver Strobe
Enable
Receiver Strobe hold time
Strobe – Forces outputs low, logic low
inhibits reception
Min Max
±0.22 ±0.88
Unit
VPK
-
20
VPK-TO-PK
-
5
VPK-TO-PK
-
10^{-9 Volts-Seconds}
- _±0.13
VPK
-
30
nsec
-
30
nsec
High 2.4
-
Low -
0.4
5
-
20
-
V
V
nsec
nsec
Aeroflex Circuit Technology
5
SCDCT1469 REV A 3/22/00 Plainview NY [phone]