ARX4810 Datasheet, PDF (1/6 Pages) Aeroflex Circuit Technology – ARX4810 & 4810FP Universal Dual Transceivers for MIL-STD-1553 & MACAIR A3818, A5690, A5232 & A4905

ARX4810 & 4810FP Universal Dual
Transceivers for MIL-STD-1553
& MACAIR A3818, A5690, A5232 & A4905
Features
• World’s smallest dual "Universal Transceiver"
0.3" X 1.2" Package
• Dual transceiver meets military data bus
requirements, MIL-STD-1553 and Macair specs
• Low power dissipation at full output power
• +5 / -15 Volt Power Supply Operation
• Voltage source output for higher bus drive power
• Monolithic construction using linear ASICs
• Processed and screened to MIL-STD-883 specs
• MIL-PRF-38534 Compliant Devices Available
• DESC SMD (Standard Military Drawing)
A ^{EARRUOXSFA4L-88E81X3079}
ARX4810 Dual Universal Transceiver
TX DATA IN
TX DATA IN
TX INHIBIT
+5 V
-15 V to -12V
GROUND
DRIVER
INPUT
AMP
SHAPING
REFERENCE
ACTIVE
FILTER
OUTPUT
STAG E
TX/RX
TX/RX
CO MP.
RX DATA OUT
CO MP.
RX DATA OUT
STROBE
Block Diagram (without transformer), 1/2 of unit shown
CIRCUIT TECHNOLOGY
www.aeroflex.com
General Description
The Aeroflex Circuit Technology
Models ARX4810 and ARX4810FP
are new generation monolithic
transceivers which provide full
compliance with MIL-STD-1553 and
Macair data bus requirements in the
smallest packages with low power
consumption and two power supply
operation.
The dual channel Model ARX4810
and Model ARX4810FP perform the
front-end analog function of inputting
and outputting data through a
transformer to a MIL-STD-1553 or
Macair data bus.
Design of these transceivers reflects
particular attention to active filter
performance.This results in low bit
and word error rate with superior
waveform purity and minimal zero
crossover distortion. Efficient
transmitter electrical and thermal
design provides low internal power
dissipation and heat rise at high as
well as low duty cycles.
Each channel of the dual transceiver
is completely separate from the other
and fully independent. This includes
power leads as well as signal lines.
Hence, each channel may be
connected to a different data bus with
no interaction.
Transmitter
The Transmitter section accepts
bi-phase TTL data at the input and
when coupled to the data bus with a
1:1 transformer, isolated on the data
bus side with two 52.5 Ohm fault
isolation resistors, and loaded by two
eroflex Circuit Technology – Data Bus Modules For The Future © SCD4810 REV B 8/12/98