TREK-520_15 Datasheet, PDF (1/2 Pages) Advantech Co., Ltd. – RISC Compact In-vehicle Computing Box for Fleet Management

TREK-520
RISC Compact In-vehicle Computing
Box for Fleet Management
Features
ƒƒ TI Cortex-A8 AM37X Series SOC
ƒƒ Support WinCE 6.0 & Embedded Linux (by project-based)
ƒƒ Vehicle diagnostic interface with configurable protocols support: CAN
(J1939, OBD-II/ISO-15765) and J1708 (J1587)
ƒƒ Built-in GNSS, WLAN, Bluetooth and WWAN
ƒƒ Built-in backup battery for roadside assistance and emergency
(by project-based)
ƒƒ Intelligent Vehicle Power Management: Ignition on/off delay, wake up
event controls and system health monitoring and diagnostic ^(*3)
ƒƒ Wide working temperature, 12/24V Car power system
compliant (ISO 7637-2) and Anti-shock/vibration
(MIL-STD-810G & 5M3)
ƒƒ IP54 available with IP protection box
Introduction
TREK-520 is a RISC box Mobile Data Terminal (MDT). The radio frequency options and low power consumption make TREK-520 suitable for local fleet management, especially
small trucks, local deliveries, government fleets and taxis. TREK-520 can operate in harsh environments and functions in extreme temperatures (-30° C ~ 70° C) using fluctuating
car power and resists shock and vibration. With a suspend/wakeup feature, TREK-520 supports a 24/7 monitoring mechanism with periodical, digital input & WWAN wakeup . ^(*3)
Specifications
Core
Storage
Display
Sensor
I/O
RF
Power
Processor
Memory
Graphic
O.S
SD Card
Smart Display Port ^(*2)
G-Sensor
Reset Button
Vehicle I/O Port
Standard I/O Port
Audio Jack
LED
WLAN + Bluetooth
WWAN
GNSS
Antenna
Voltage input
Intelligent Vehicle Power
Management (iVPM 1.0)
Backup battery
TI Cortex-A8 AM3703 (Single Core, 800MHz); AM3715 (Single Core, 1GHz) by project-based
512MB LPDDR on board; 1GB LPDDR by project-based
POWERVR SGX™ Graphics Accelerator of OpenGLES 1.1/2.0, OpenVG1.0 by project-based
WinCE 6.0 R3 core version; Linux V2.6.37 by project-based
1 x internal non-accessible 4GB SD, support system boot up
1 x external accessible push-push type SD slot
12V/1A power output for TREK-303
1 x 18-bits LVDS (Resolution: 800 x 480)
1 x Line-Out (*1) (For Speakers on TREK-30X)
2 x UART (TX/RX) (For T/S, Hot keys, brightness, light sensor control)
1 x USB 2.0 Type A
1 x PWR Button Signal
1 x Reset Button Signal
3-Axis ±2/±4/±8/±16 g
1 x Reset button
2 x CAN Bus (Support Raw CAN, J1939, OBD-II/ISO 15765; F/W configurable)
1 x J1708 (Support J1587)
2 x Isolated DI (Dry contact)
2 x Isolated DO (Open collector output, driving by replay)
1 x USB Client Mini-B
1 x USB 2.0 Host Type A
1 x SIM Card Slot
1 x High Speed Full RS-232, (Optional DB-9 Pin 9 with 12V/1A)
1 x MIC/Mono Line In
1 x Stereo Line Out
4 x LEDs (Power (Red), WLAN/BT (Green), WWAN (Green), GPS (Blue))
IEEE 802.11 b/g/n + Bluetooth V2.1+EDR on board
HSPA+/UMTS, GSM/GPRS/EDGE: Telit HE-910D via mini PCIe slot
CDMA, EV-DO: Telit DE-910 via mini PCIe slot
Build-in GlobalSat EB-5662RE module on board
3 x SMA type antenna hole for GPS/ WWAN/ WLAN+BT
Supports 12/24 V car power system. (ISO 7637-2 & SAE J1113 compliant.)
6V ~ 32V DC input without backup battery; 12V ~ 32V DC input with backup battery by project-based
System power on/off/suspend management (e.g. Programmable Ignition On/Off Time delay)
Support Wake up Events:
- Alarm (RTC) Wake up.
- Wake up by Call/SMS.
System power protection
System healthy monitoring and diagnostic (e.g. Programmable Car_Battery _Low Protection)
7.4V 2000mAH Li-ion battery by project-based
*1: Support single audio stream only. (i.e. The Line-Out interface in "Smart Display Port" and "Audio Jack" share the same audio path).
*2: Default is ok for TREK-303; TREK-306 (1024x768) by project-based.
All product specifications are subject to change without notice
http://www.advantech-dlog.com
Regional contact:
Last updated : 30-Jan-2015