CN0287 Datasheet, PDF (8/9 Pages) Analog Devices – Devices Connected

CN-0287
Test
Launch the evaluation software. After USB communications are
established, the SDP-B board can be used to send, receive, and
capture data from the EVAL-CN0287-SDPZ board.
Figure 11 shows a photo of the EVAL-CN0287-SDPZ evaluation
board connected to the SDP board. Information regarding the
SDP-B board can be found in the SDP-B User Guide.
Information and details regarding test setup and calibration,
and how to use the evaluation software for data capture can be
found in the CN-0287 Software User Guide.
Circuit Note
Connectivity for Prototype Development
The EVAL-CN0287-SDPZ evaluation board is designed to use
the EVAL-SDP-CB1Z SDP-B board; however, any
microprocessor can be used to interface to the SPI interface
through the PMOD connector J6. The pin definition of PMOD
connector can be found in the schematics of CN0287 evaluation
board in CN-0287 Design Support Package. In order for
another controller to be used with the EVAL-CN0287-SDPZ
evaluation board, software must be developed by a third party.
Figure 11. EVAL-CN0287-SDPZ Evaluation Board Connected to the EVAL-SDP-CB1Z SDP-B Board
Rev. C | Page 8 of 9