OP471_15 Datasheet, PDF (7/16 Pages) Analog Devices – High Speed, Low Noise Quad Operational Amplifier

OP471
500⍀
5k⍀
1/4
OP471
V₁ 20V p-p
50k⍀
50⍀
1/4
OP471
V₂
CHANNEL SEPARATION = 20 LOG
V₁
V₂ / 1000
Figure 2. Channel Separation Test Circuit
+18V
2
4
6
A
1
B
7
+1V
3
11
+1V
5
–18V
9
13
8
C
D
14
–1V
10
12
–1V
Figure 3. Burn-In Circuit
APPLICATIONS INFORMATION
Voltage and Current Noise
The OP471 is a very low-noise quad op amp, exhibiting a typical
voltage noise of only 6.5 Hz @ 1 kHz. The low noise character-
istic of the OP471 is, in part, achieved by operating the input
transistors at high collector currents since the voltage noise is
inversely proportional to the square root of the collector current.
Current noise, however, is directly proportional to the square
root of the collector current. As a result, the outstanding voltage
noise performance of the OP471 is gained at the expense of current
noise performance which is typical for low noise amplifiers.
To obtain the best noise performance in a circuit, it is vital to
understand the relationship between voltage noise (e_n), current
noise (i_n), and resistor noise (e_t).
Total Noise and Source Resistance
The total noise of an op amp can be calculated by:
( ) ( ) ( ) ²
2
2
E_n = e_n + i_nR_S + e_t
where:
E_n = total input referred noise
e_n = op amp voltage noise
i_n = op amp current noise
e_t = source resistance thermal noise
R_S = source resistance
The total noise is referred to the input and at the output would
be amplified by the circuit gain.
100
OP11
10 ^OP400
OP471
OP470
RESISTOR
NOISE ONLY
1
100
1k
10k
100k
RS – SOURCE RESISTANCE – ⍀
Figure 4. Total Noise vs. Source Resistance (Including
Resistor Noise) at 1 kHz
100
OP11
OP400
10
OP471
OP470
RESISTOR
NOISE ONLY
1
100
1k
10k
100k
RS – SOURCE RESISTANCE – ⍀
Figure 5. Total Noise vs. Source Resistance (Including
Resistor Noise) at 10 Hz
Figure 4 shows the relationship between total noise at 1 kHz
and source resistance. For R_S < 1 kW the total noise is domi-
nated by the voltage noise of the OP471. As R_S rises above 1 kW,
total noise increases and is dominated by resistor noise rather
than by voltage or current noise of the OP471. When R_S exceeds
20 kW, current noise of the OP471 becomes the major contributor
to total noise.
Figure 5 also shows the relationship between total noise and source
resistance, but at 10 Hz. Total noise increases more quickly
than shown in Figure 4 because current noise is inversely pro-
portional to the square root of frequency. In Figure 5, current
noise of the OP471 dominates the total noise when R_S > 5 kW.
From Figures 4 and 5, it can be seen that to reduce total noise,
source resistance must be kept to a minimum. In applications
with a high source resistance, the OP400, with lower current
noise than the OP471, will provide lower total noise.
REV. A
–7–