OP97_07 Datasheet, PDF (5/16 Pages) Analog Devices – Low Power, High Precision Operational Amplifier

ABSOLUTE MAXIMUM RATINGS
Absolute maximum ratings apply to both DICE and packaged
parts, unless otherwise noted.
Table 3.
Parameter
Rating
Supply Voltage
Input Voltage¹
Differential Input Voltage²
Differential Input Current²
Output Short-Circuit Duration
Operating Temperature Range
OP97E, OP97F (P, S)
Storage Temperature Range
Junction Temperature Range
Lead Temperature (Soldering, 60 sec)
±20 V
±20 V
±1 V
±10 mA
Indefinite
−40°C to +85°C
−65°C to +150°C
−65°C to +150°C
300°C
1 _{For supply voltages less than ±20 V, the absolute maximum input voltage is}
equal to the supply voltage.
2 _{The inputs of the OP97 are protected by back-to-back diodes. Current-}
limiting resistors are not used in order to achieve low noise. Differential
input voltages greater than 1 V cause excessive current to flow through the
input protection diodes unless limiting resistance is used.
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
OP97
THERMAL RESISTANCE
θJA is specified for the worst-case conditions, that is, a device
soldered in a circuit board for surface-mount packages.
Table 4.
Package Type
8-Lead PDIP (P Suffix)
8-Lead SOIC (S Suffix)
θJA1
θJC
103
43
158
43
Unit
°C/W
°C/W
1 _{θJA is specified for worst-case mounting conditions, that is, θJA is specified for}
device in socket for PDIP package; θJA is specified for device soldered to
printed circuit board for SOIC package.
ESD CAUTION
Rev. F | Page 5 of 16