EVAL-ADGS1412SDZ Datasheet, PDF (5/12 Pages) Analog Devices – SPI interface with error detection

EVAL-ADGS1412SDZ User Guide
EVALUATION BOARD SOFTWARE
INSTALLING THE SOFTWARE
The EVAL-ADGS1412SDZ evaluation board uses the Analog
Devices Analysis Control Evaluation (ACE) software. ACE is a
desktop software application that allows the evaluation and
control of multiple evaluation systems.
The ACE installer installs the necessary SDP drivers and .NET
Framework 4 by default. Install ACE before connecting the SDP.
The ACE software and access to full instructions on how to
install and use ACE can be found on the Analog Devices
website.
After the installation is finished, the EVAL-ADGS1412SDZ
evaluation board plug-ins appear when opening ACE.
INITIAL SET UP
To set up the evaluation board, complete the following steps:
1. Connect the evaluation board to the SDP board and
connect the SDP board to the computer via a USB cable.
2. Power the evaluation board as described in the Power
Supplies section.
3. Run the ACE application. The EVAL-ADGS1412SDZ
board plug-ins appear in the attached hardware section of
the Start tab.
4. Double-click on the evaluation board plug-in to open the
evaluation board view seen in Figure 2.
5. The chip block diagram can be accessed by double-clicking
on the ADGS1412 chip (see Figure 2). This view provides a
basic representation of functionality of the board. The main
functions are labeled in Figure 3.
UG-1067
Figure 2. Evaluation Board View of the EVAL-ADG1412SDZ
Figure 3. Chip Block Diagram View for the ADG1412
Rev. 0 | Page 5 of 12