EVAL-AD7899CB Datasheet, PDF (5/12 Pages) –

EVAL-AD7899CB
SOCKETS
There are six input sockets relevant to the operation of the
AD7899 on this evaluation board. The function of these
sockets is outlined in Table III.
Table III. Socket Functions
Socket
SK1
SK2
SK3
SK4
SK5
SK6
Function
Sub-Miniature BNC Socket for the analog
input.
Sub-Miniature BNC Socket for the exter-
nal reference
Sub-Miniature BNC Socket for external
V_DRIVE supply.
Sub-Miniature BNC Socket for BUSY
output.
Sub-Miniature BNC Socket for external
CONVST input.
Sub-Miniature BNC Socket for the exter-
nal CLKIN input.
CONNECTORS
There are two connectors on the AD7899 evaluation board
as outlined in Table IV.
Table IV. Connector Functions
Connector
J1
J2
Function
96-Way Connector for Parallel Interface con-
nections.
External +12V, -12V +5V & A_GND power
connector.
OPERATING WITH THE EVAL-BOARD
CONTROLLER
The evaluation board can be operated in a stand-alone mode
or operated in conjunction with the EVAL-BOARD CON-
TROLLER. The EVAL-BOARD CONTROLLER is avail-
able from Analog Devices under the order entry
"EVAL-BOARD CONTROLLER". When operated with
this control board, all supplies and control signals to operate
the AD7899 are provided by the EVAL-BOARD CON-
TROLLER. Software to communicate with the Control
Board and AD7899 is provided with the AD7899 evaluation
board package. This EVAL-BOARD CONTROLLER will
also operate with all Analog Devices evaluation boards which
end with the letters CB in their title.
The 96-way connector on the EVAL-AD7899CB plugs
directly into the 96-way connector on the EVAL-BOARD
CONTROLLER. The EVAL-BOARD CONTROLLER
provides all the supplies for the evaluation board. Itis
powered from a 12VAV transformer. Suitable transformers
are available from Analog Devices as an accessory under the
following part numbers:
EVAL-110VAC-US:
For use in the U.S. or Japan
EVAL-220VAC-UK:
For use in the U.K.
EVAL-220VAC-EU:
For use in Europe
These transformers are also available for other suppliers
including Digikey (U.S.) and Campbell Collins (U.K.).
Connection between the EVAL-BOARD CONTROLLER
and the serial port of a PC is via a standard Centronics printer
port cable which is provided as part the EVAL-BOARD
CONTROLLER package. Please refer to the manual which
accompanies the EVAL-BOARD CONTROLLER for more
details on the EVAL-BOARD CONTROLLER package.
REV. 0
–5–