CN-0285 Datasheet, PDF (5/5 Pages) Analog Devices – Broadband Low Error Vector Magnitude (EVM) Direct Conversion Transmitter

Circuit Note
Getting Started
See the UG-521 User Guide for software installation and test setup.
The user guide also includes the block diagram, the application
schematic, the bill of materials, and the layout and assembly
information. In addition, see the ADF4351 data sheet and the
ADL5375 data sheet for additional details.
Functional Block Diagram
See Figure 1 and Figure 6 in this document, and also see the
UG-521 User Guide.
Setup and Test
After setting up the equipment, use standard RF test methods to
measure the sideband suppression of the circuit.
LEARN MORE
CN0285 Design Support Package:
http://www.analog.com/CN0285-DesignSupport
ADIsimPLL Design Tool
ADIsimPower Design Tool
ADIsimRF Design Tool
AN-0996 Application Note. The Advantages of Using a
Quadrature Digital Upconverter (QDUC) in Point-to-Point
Microwave Transmit Systems. Analog Devices.
AN-1039 Application Note. Correcting Imperfections in IQ
Modulators to Improve RF Signal Fidelity. Analog Devices.
Data Sheets and Evaluation Boards
ADF4351 Data Sheet
ADF4351 Evaluation Board
ADL5375 Data Sheet
ADL5375 Evaluation Board
ADP150 Data Sheet
ADP3334 Data Sheet
REVISION HISTORY
2/13—Revision 0: Initial Version
CN-0285
(Continued from first page) Circuits from the Lab circuits are intended only for use with Analog Devices products and are the intellectual property of Analog Devices or its licensors. While you
may use the Circuits from the Lab circuits in the design of your product, no other license is granted by implication or otherwise under any patents or other intellectual property by
application or use of the Circuits from the Lab circuits. Information furnished by Analog Devices is believed to be accurate and reliable. However, Circuits from the Lab circuits are supplied
"as is" and without warranties of any kind, express, implied, or statutory including, but not limited to, any implied warranty of merchantability, noninfringement or fitness for a particular
purpose and no responsibility is assumed by Analog Devices for their use, nor for any infringements of patents or other rights of third parties that may result from their use. Analog Devices
reserves the right to change any Circuits from the Lab circuits at any time without notice but is under no obligation to do so.
©2013 Analog Devices, Inc. All rights reserved. Trademarks and
registered trademarks are the property of their respective owners.
CN10921-0-2/13(0)
Rev. 0 | Page 5 of 5