UG-361 Datasheet, PDF (4/8 Pages) Analog Devices – High Speed Evaluation Board for Full Duplex M-LVDS Transceivers

UG-361
Evaluation Board User Guide
SIGNAL
GENERATOR
3.3V POWER
SUPPLY
3.3V POWER
SUPPLY
EVAL-ADN469xEFDEBZ
J9
RE
RO GND VCC ^GND
J2
J1
DE ^{LK1 RO}
J5
A
J3
AB
DI
RE
DE
GND
J6
B
J4 LK2 DI GND
Y Z GND
GND ^J8
J7
EVAL-ADN469xEFDEBZ
J9
RE
RO GND VCC ^GND
J2
J1
DE ^{LK1 RO}
J5
A
J3
AB
DI
RE
DE
GND
J6
B
J4 LK2 DI GND
Y Z GND
GND ^J8
J7
SEE NOTE
OSCILLOSCOPE
NOTES
1. REPLACE 50Ω RESISTORS WITH 100Ω WHEN EVALUATING TWO BOARDS CONNECTED TOGETHER.
Figure 4. EVAL-ADN469xEFDEBZ Two Board Point-to-Point Evaluation
3.3V POWER
SUPPLY
SEE NOTE 1
TEST NODE
CONTROLLER
EVAL-ADN469xEFDEBZ
J9
RE
RO GND VCC ^GND
J2
J1
DE ^{LK1 RO}
J5
A
J3
AB
DI
RE
DE
GND
J6
B
J4 LK2 DI GND
Y Z GND
GND ^J8
J7
SLAVE
R_T
R_T
AB
Z Y MASTER A B
Z Y SLAVE
NODE 1
NODE 2
R_T
AB
R_T
ZY
SLAVE
NODE N
NOTES
1. REMOVE 50Ω TERMINATION RESISTORS FROM EVALUATION BOARD.
2. MAXIMUM NUMBER OF NODES: 32.
3. R_T IS EQUALTO THE CHARACTERISTIC IMPEDANCE OF THE CABLE USED.
Figure 5. EVAL-ADN469xEFDEBZ Application Evaluation Connected to Bus and Control Board
Table 2. Jumper Configuration
Link Connection Description
LK1 A
Connects RE to VCC (disables receiver output). Disconnect J2 input.
B
Connects RE to GND (enables receiver output). Disconnect J2 input.
None
Allows RE input on J2.
LK2 A
Connects DE to VCC (enables driver outputs). Disconnect J3 input.
B
Connects DE to GND (disables driver outputs). Disconnect J3 input.
None
Allows DE input on J3.
Rev. 0 | Page 4 of 8