AD8190 Datasheet, PDF (4/24 Pages) Analog Devices – 2:1 HDMI/DVI Switch with Equalization

AD8190
Parameter
SERIAL CONTROL INTERFACE⁵
Input High Voltage, VIH
Input Low Voltage, VIL
Output High Voltage, VOH
Output Low Voltage, VOL
Conditions/Comments
Min
Typ Max
Unit
2
V
0.8
V
2.4
V
0.4
V
1 _{Differential interpair skew is measured between the TMDS pairs of a single link.}
2 _{AD8190 output meets the transmitter eye diagram as defined in the DVI Standard Revision 1.0 and the HDMI Standard Revision 1.2a.}
3 _{Cable output meets the receiver eye diagram mask as defined in the DVI Standard Revision 1.0 and the HDMI Standard Revision 1.2a.}
4 _{Typical value assumes only the selected HDMI/DVI link is active with nominal signal swings and that the unselected HDMI/DVI link is deactivated. Minimum and}
maximum limits are measured at the respective extremes of input termination resistance and input voltage swing.
5 _{The AD8190 is an I}2_{C slave and its serial control interface is based on the 3.3 V I}2_{C bus specification.}
Rev. 0 | Page 4 of 24