3B45_15 Datasheet, PDF (4/8 Pages) Analog Devices – Isolated Frequency Input

3B45 / 3B46
Large Signal, V_in > 4 V pk-pk
Output, 100 kHz Bandwidth
Output, Ripple
Output Step Response Time
Input-to-Output, Continuous
Transient
1 kΩ Source Imbalance, 50/60 Hz
Continuous
Transient
Voltage Output Protection
Current Output Protection
±15 V dc Supplies
Rated Operation
Current
Sensitivity
+24 V dc Loop Supply
Rated Operation
Current
Sensitivity
Mechanical Dimensions
Temperature Range
Rated Performance
Storage
Relative Humidity
RFI Susceptibility
82 kΩ
*
Noise
75 µV rms
*
10 mV rms @ 10% F_span, maximum *
Refer to Model Table
*
Common-Mode Voltage (CMV)
±1500 V peak, maximum
*
ANSI/IEEE C37.90.1-1989
*
Common-Mode Rejection (CMR)
100 dB
*
Input Protection
220 V rms maximum
*
ANSI/IEEE C37.90.1-1989
*
Continuous Short to Ground
*
130 V rms, continuous
*
Power Supply Voltages⁵
±(11.5 V dc to 16.5 V dc)
±16 mA
±0.01% span/V
*
±19 mA
*
+13.5 V dc to +30 V dc
*
+27 mA @ l_out = 20 mA
*
±0.0002% span/V
*
3.15" x 3.395" x 0.775"
*
(80.0 mm x 86.2 mm x 19.7 mm)
Environmental
-25°C to +85°C
*
-55°C to +85°C
*
0 to 95% @ +60°C noncondensing *
±0.5% Span error @ 400 MHz, 5
*
Watt, 3 ft
* Specifications same as model 3B45.
1 _{For a 0 to 20 mA range, a typical minimum output current is 10 µA.}
2 _{Includes the combined effects of repeatability, hysteresis, and nonlinearity.}
3 _{With respect to the voltage output.}
4 _{A wide range of custom zero suppression and span is available with the 3B45-00 and 3B46-00 models, using the AC1310 ranging card.}
5 _{+24 V dc loop power is required for driving the current output at loads up to 850Ω. If a current output load of 400Ω or less is applied, +15 V dc is sufficient for loop power. If only voltage output is}
used, loop power is not required.
Specifications subject to change without notice.
Rev. 0 | Page 4 of 8